A Round Gauge kit for the Ford Australia Falcon XY (GT and GS dash)
Built from the factory gauge sizes below: one digital gauge per hole.
Factory gauges
6 round instruments in the factory dash
| Instrument | Original size | How it works | Round Gauge |
|---|---|---|---|
| Speedometer (140 mph) | Not publishedMedium13 | Cable drive | 100 mm To measureNo source gives the dial or hole size. 100 mm is a provisional pick; measure the opening. Cable drive is assumed for the period; the sources we read do not state it. |
| Tachometer (8000 rpm, 351 Cleveland) | Not publishedMedium13 | Electronic (voltage trigger) | 100 mm To measureThe earlier XW GT used a 6000 rpm tach with the Windsor V8 and 8000 rpm with the Cleveland. Measure the opening. |
| Fuel gauge | Not publishedMedium1 | Other | 52 mm To measureProvisional 52 mm match only; measure. |
| Oil pressure gauge | Not publishedMedium1 | Other | 52 mm To measureProvisional 52 mm match only; measure. Check whether your gauge is electric or mechanical before planning a sender. |
| Water temperature gauge | Not publishedMedium1 | Other | 52 mm To measureProvisional 52 mm match only; measure. |
| Clock (analogue) | Not publishedMedium13 | Clock | 52 mm To measureElectric analogue clock on the XW GT. Many owners keep the clock original even with digital gauges. |
Electrical facts for a gauge swap
Earth polarity, stabiliser, senders and signal types.
The factory dash and its variants
Ford Australia released the XY Falcon in October 1970 as a facelift of the XW, and built it until 1972.
The range included the Fairmont, the GT sedan and, from May 1971, the GT-HO Phase III.Medium2
About 1,557 XY GTs were built from September 1970 to December 1971, 300 of them Phase IIIs. A small number went to South Africa as the Fairmont GT.Medium1
The gauge list here describes the GT dash: 140 mph speedometer, 8000 rpm tach, fuel, oil-pressure and water-temperature gauges and an analogue clock. Wikipedia lists the Phase III with the same speedometer and tach.Medium1
A GS Rally Pack was optional on Falcon 500, Futura and Fairmont sedans and wagons. Check which instruments a given GS car actually carries, because base cars used a simpler dash.Medium2
How the original instruments work
The tach range followed the engine.
The XW GT used a 6000 rpm tach behind the Windsor V8 and an 8000 rpm unit behind the Cleveland, and the XY GT carried the Cleveland's 8000 rpm tach.Medium31
Fuel, oil-pressure and temperature readings come from senders on the tank and engine. The sources we read do not publish their resistance ranges or say whether the oil gauge is electric or mechanical.Low1
What owners replace and why
The tach face is a quick originality check on a GT.
Cleveland cars read to 8000 rpm, so a 6000 rpm face points to a Windsor-era part.Medium31
The GT instrument list, including the clock and oil-pressure gauge, is the reference when judging whether a dash is complete. GS Rally Pack cars are a separate option and need checking on their own terms.Low12
Going digital without losing the look
On a car this collectible, a digital set should go into a spare dash panel or cluster so the original stays untouched.
Measure each opening before ordering, because no source publishes the factory dial sizes.Low1
GPS speed avoids the cable and the calibration that comes with axle-ratio changes. Take the tach signal the factory tach uses, identified from a wiring diagram for your car.Low1
Keep the factory fuel sender only if the new gauge reads its measured range. Oil and temperature need senders matched to the new gauges.Low1
Common faults with the original gauges
1Tach face does not match the engine
2Clock or a small gauge missing from a GT dash
Usual causeParts lost or swapped over the car's life
FixCompare the dash with the published GT list (speedometer, tach, fuel, oil pressure, water temperature and clock) and source correct-series parts.Medium1
Restoration tips
Keep it original and reversible
Frequently asked
What gauges does an XY Falcon GT have?
The XY GT has a 140 mph speedometer, an 8000 rpm tachometer, fuel, oil-pressure and water-temperature gauges, and an analogue clock. Ignition, high-beam and brake warnings are lights. Wikipedia lists the GT-HO Phase III with the same speedometer and tach.Medium1
Is the XY GT tacho 6000 or 8000 rpm?
8000 rpm. The XY GT used the 351 Cleveland, and Cleveland GTs carried an 8000 rpm tach. The 6000 rpm unit belongs to Windsor-engined XW GTs.Medium13
What is the GS Rally Pack on an XY Falcon?
It was an option on Falcon 500, Futura and Fairmont sedans and wagons that added sporty equipment to cars that were not GTs. The exact instruments vary, so check a GS car's dash against its build details rather than assuming GT gauges.Medium2
Did the GT-HO Phase III have different gauges from the GT?
Wikipedia lists the same 140 mph speedometer and 8000 rpm tachometer for the GT and the Phase III. On the earlier XW, the only interior difference between GT and GT-HO was the glovebox badge.Medium13
Can I fit digital gauges to an XY Falcon without cutting the dash?
Yes, if you build them into a spare dash panel or cluster and keep the original intact. No source we found publishes the factory dial sizes, so measure each opening before ordering gauges.Low1
Related cars
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
- Ford XY Falcon GT · Wikipedia · reference · retrieved 2026-11-04
- Ford Falcon (XY) · Wikipedia · reference · retrieved 2026-11-04
- Info guide: 1969-1970 Ford Falcon XW GT · Classic Register · community · retrieved 2026-11-04
Markets: Australia, South Africa (as Fairmont GT). Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.

