458 F142: every channel it can give you
No public data maps this car's chassis channels yet. 17 more chassis and driver channels are on the car, waiting for GAINS discovery. Plus 25 Hz GPS and a motion sensor in the dongle itself.
Channels
Every channel the F142 is expected to give, by group. Filter by how it arrives.
Driver inputs
Wheels and chassis
Temperatures and pressures
Stability systems
Built into the dongle, on every car
How the data gets out
Where the F142's sensors live and how GAINS reaches them.
Listen, then read the modules
Discovery first listens for the car's data stream at the OBD-II port; anything it can't hear, it requests from the modules with read-only reads.
Telemetry Dongle ProDiscovery on your 458
The 17 channels marked “To discover” are learned once, from your car, then added for every F142 owner.
- Plug in and identify
The dongle finds the bus speed by listening only, reads the VIN and matches the car's data pattern to our database.
about 1 min - Guided steps, parked
The app walks you through each control for a few seconds: wheel lock to lock, brake light then firm, throttle (engine off), clutch, every gear, handbrake, stability-control button. The dongle records what changes on the car's data stream.
about 5 min - Module read
With the car parked, the dongle asks each module (ABS, gearbox, body) which values it can report. Read-only requests: nothing is written or changed.
about 5–10 min, automatic - Short drive
A normal drive with a few stops, steady speeds and turns. The dongle matches unknown values against its 25 Hz GPS and motion sensor to find wheel speeds, yaw rate and g-forces.
10–15 min - Results
Matched channels appear in the app. Anything that needs a closer look is checked by us and added later; you get a notification, and every owner of the same car gets the channel too.
most right after the drive
First time: about 25–30 minutes, once per car. Times are estimates until measured on real cars. Discovery only listens and reads: it never writes to the car, clears codes or bypasses security.
FAQ
Can I log steering angle and brake pressure on a 458 F142 through the OBD-II port?
The F142 is expected to carry them (stability control (ESC / F1-Trac)), but no public data maps them yet. GAINS discovery learns them from a capture of your car: listen, then read the modules. A standard OBD2 scan tool won't show them.
What OBD-II protocol does the 458 F142 use?
CAN (ISO 15765). Its engine, stability and dash modules also share an internal CAN bus.
How long does discovery take on a F142?
The first time, about 25–30 minutes, once per car (estimate): guided steps while parked, a read-only module check and a short drive. After that the dongle recognises the car when you plug in.
Channel lists combine public vehicle data from the open-source community with the equipment this generation is known to carry. “Expected” and “To discover” channels are not yet confirmed by our own logs, and equipment varies by market, trim and year. Vehicle names identify the cars only; GAINS is not affiliated with Ferrari. Specifications are pre-release and may change before launch.

