How it works
The burn takes a roughly fixed time, so at higher rpm the crank turns further while the flame develops.
Spark must start earlier in crank degrees to place peak pressure at the right point after top dead center. That is why advance generally rises with engine speed.42
Load works the other way. At light load the cylinder holds less, more diluted charge that burns slowly and resists knock, so it tolerates and needs more advance. At high load the denser charge burns faster and is more knock-prone, so the knock limit usually caps advance below the best-torque point.41
The base map is only the first step. Factory strategies stack corrections for intake and coolant temperature, knock retard, idle speed control, transient conditions and torque reduction requests. The final advance logged by the ECU can differ substantially from the table value.Medium15
In tuning
Ignition guidance here is qualitative only.
Advance should approach best-torque timing only where the engine is not knock-limited, and stay retarded from the knock limit with margin elsewhere. Make small changes, log knock activity and torque, and stop adding timing when torque stops rising.Medium46
Keep the table smooth across rpm and load, because the ECU interpolates and sudden steps cause torque jumps. Verify that the timing the ECU reports matches the crank with a timing light before trusting any table.Medium17
Myths vs facts
Myth More timing always means more power.
Fact Torque peaks at a best-torque timing and falls if advance goes further. Past that point, extra advance mainly raises cylinder pressure, heat and knock risk.4
Myth The number in the ignition table is the timing the engine runs.
Fact Corrections for temperature, knock, idle and torque requests modify the table value. Log final ignition advance to see what the engine actually receives.1
Frequently asked
Why does timing advance with rpm?
Combustion needs a roughly fixed amount of time to develop. As engine speed rises, the crank covers more degrees in that time, so the spark must fire earlier in crank angle to keep peak cylinder pressure at the effective point after top dead center. Charge motion also speeds burning at high rpm, so the increase is not linear.42
Why is there less timing at high load?
A full cylinder of dense charge burns faster and is far more prone to knock. Most engines become knock-limited at high load, so advance must be held back from the best-torque point. Boosted engines need even less advance as manifold pressure and charge temperature rise.46
What corrections are applied to the ignition table?
Common ones are intake air temperature, coolant temperature, knock retard, idle speed control, gear or traction torque reduction and transient corrections. Factory strategies may also adjust for fuel quality and altitude. The sum of these decides the final spark advance logged by the ECU.Medium15
How do you tune an ignition map safely?
Start conservative, change small regions in small steps, and log knock and torque each time. Stop advancing where torque stops improving or knock appears, and keep margin from the knock limit. Use load-bearing testing such as a dyno, check fuel quality, and never copy timing values from a different engine.Medium41
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
- Automotive Handbook, 10th edition (2018) · Robert Bosch GmbH / Wiley · book · retrieved 2026-10-27
- Ignition timing · Wikipedia · reference · retrieved 2026-10-27
- Engine control unit · Wikipedia · reference · retrieved 2026-10-27
- Internal Combustion Engine Fundamentals, 2nd edition (2018) · McGraw-Hill (John B. Heywood) · book · retrieved 2026-10-27
- Motronic · Wikipedia · reference · retrieved 2026-10-27
- Engine knocking · Wikipedia · reference · retrieved 2026-10-27
- Bilinear interpolation · Wikipedia · reference · retrieved 2026-10-27

