Germany · 1967-1979 (Germany); later in Brazil and Mexico · VDO, Motometer instruments

Volkswagen Type 2 (T2) Bay Window bus gauges

Three-pod dashNo factory tachClock optional 1968-1979Cable speedoTube sender to early 1973, lever sender afterStabiliser 113 957 099 A on 1973-1979

VW bus gauges on the T2 Bay Window are a three-pod VDO dash: a cable-driven speedometer, a fuel gauge and a third hole that holds the optional clock or a blank. VW never offered a factory tachometer, so owners often fit one in the clock hole with an adapter ring. Pod diameters are not published, so measure before buying.Medium123

3 gauges · 100 mm + 80 mm

A Round Gauge kit for the Volkswagen Type 2 (T2) Bay Window bus

Built from the factory gauge sizes below: one digital gauge per hole.

Factory gauges

3 round instruments in the factory dash

InstrumentOriginal sizeHow it worksRound Gauge
Speedometer (centre pod)VW 211 957 057 series (miles)Not publishedMedium17Cable drive100 mm To measureNo source we found gives the pod diameter. The match is a placeholder to confirm by measuring the pod.
Fuel gaugeVW 211 957 063 B (grey face, 1967-1973)Not publishedLow34Thermal (bimetal)80 mm To measurePlaceholder match. Measure the pod before choosing a size.
Clock or blank (third pod)Clock panels 211 957 051 F (1973-1975) and 211 957 051 K (1976-1979)Not publishedMedium12Clock80 mm To measureA VDO tach fits this hole with a mounting ring, which means the hole is larger than common small gauges. Placeholder match until measured.

Electrical facts for a gauge swap

Earth polarity, stabiliser, senders and signal types.

System voltage and earth12 V, negative earthNot stated in the sources gathered for this page; confirm at the battery.Researched, unverified1
Fuel gauge voltage stabiliserVW 113 957 099 A on T2 Bay 1973-1979Sourced · medium4
Fuel sender
  • Tube type 211 919 051 to about February 1973
  • Lever type 211 919 051 A after
Check the chassis number; sellers give the cut-off as chassis 213 2138 900.Sourced · medium56
Speedometer drive
  • Mechanical cable
  • LHD cable 2485 mm, RHD cable 2510 mm
Sourced · medium7
Tach signalNo factory tachAdded tachs on points ignition take their signal from the coil; confirm with the tach maker.Sourced · medium1

The factory dash, with history and variants

The Bay Window dash has three round pods.

The speedometer sits in one, the fuel gauge in another, and the third hole carries the clock or a blank cover.Medium12

Speedometers ran through the 211 957 057 series. Later letters added a trip odometer or, on 1976-1979 buses, a catalyst service counter.Medium1

The clock was optional from 1968 to 1979. Early clocks have a grey face with a light centre disc and are mechanical; 1973-on clocks are quartz, with a black face from 1976.Medium1

European commercial buses could carry a tachograph that recorded speed and driving time on a paper disc. VW never listed a tachometer, so a bus tach offered for sale is usually a unit from another model.Medium1

How the original instruments work

The speedometer is driven by a cable from the front wheel area.

Cable length differs by drive side, at 2485 mm (97.8 in) for left-hand drive and 2510 mm (98.8 in) for right-hand drive.Medium7

The fuel gauge reads a tank sender. The early tube-type sender was replaced by a lever type in early 1973, and 1973-1979 buses use the 113 957 099 A voltage stabiliser to steady the gauge supply.Medium564

What owners replace and why

Early mechanical clocks are often found broken, so owners swap in quartz clocks or reproduction units built to fit the third pod.Medium12

A tach is the most common addition. Owners fit a VDO tach in the clock hole using a mounting ring, which avoids cutting the dash.Medium1

Going digital without losing the look

A digital speedometer can read GPS or a speed sensor, which removes the long speedo cable.

Reproduction digital speedometers are sold for the Bay that fit the original pod.Low27

Keep the original fuel sender if the new gauge can read its range, and the tank stays untouched. Store the original speedometer, clock and cable so the swap can be reversed.Low51

Common faults with the original gauges

  1. 1Clock stopped

    Usual cause

    1968-1972 clocks are mechanical and often fail

    Fix

    Repair the movement or fit a quartz unit in the original case.Medium1

  2. 2Fuel gauge wrong after a sender swap

    Usual cause

    Tube and lever senders are not interchangeable across the early-1973 change

    Fix

    Match the sender to the chassis number.Medium56

  3. 3Fuel gauge erratic on a 1973-1979 bus

    Usual cause

    Failing voltage stabiliser

    Fix

    Test the stabiliser output and replace with 113 957 099 A.Low4

Restoration tips

Keep it original and reversible

  • Match the clock face to the year: grey with a disc to 1972, grey without a disc 1973-1975, black 1976-1979.Medium1
  • Be wary of any tach sold as a factory bus option; VW did not offer one.Medium1
  • Use a ring in the clock hole for an added gauge rather than cutting the pod.Medium1

Frequently asked

Did the VW Bay Window bus have a tachometer?

No, VW never offered a factory tachometer on the Bay Window bus. Commercial buses in Europe could have a tachograph, which records speed and time on a paper disc. Tachs sold as original bus parts are usually VDO units from other VW or Audi models.Medium1

Can I put a tach in the clock hole of a VW bus?

Yes, the clock hole is the usual place for an added tach. Owners fit a modern VDO tach with a mounting ring, which keeps the dash uncut. Measure the hole first, because a ring is needed to take up the gap between the gauge and the pod.Medium1

Which fuel sender does a 1974 VW bus use?

A 1974 bus uses the lever-type sender, 211 919 051 A, listed for 1974-1979 buses. Earlier buses to about February 1973 use the tube-type 211 919 051. Buses built in 1973 near the change should be checked by chassis number.Medium65

What size is a VW bus speedometer?

No source we found publishes the Bay Window speedometer pod diameter. Aftermarket listings mention 80 mm and 86 mm gauges for buses, but those are general-fit gauges, not the factory size. Measure the pod opening before ordering a gauge or ring.Low81

Why does my VW bus fuel gauge not work?

The usual causes are a failed sender, a broken sender wire or earth, or on 1973-1979 buses a failed voltage stabiliser. Check the sender type against the chassis number, test the wiring, then test the stabiliser before replacing the gauge.Low45

Related cars

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Factory dash options (speedometer, clock, tachograph) · Ratwell.com · community · retrieved 2026-11-04
  2. Smiths original style clock, dashboard mounted, grey: T2 Bus (1968-1973) · Heritage Parts Centre · vendor-doc · retrieved 2026-11-04
  3. 211 957 063 B fuel gauge, VW T2 Bay 1967-1973 · Just Kampers · vendor-doc · retrieved 2026-11-04
  4. Fuel gauge voltage stabiliser for VW Beetle 1967 on, VW T2 Bay 1973-1979 · Just Kampers · vendor-doc · retrieved 2026-11-04
  5. 1968-73 Bay Window fuel gauge sender unit (tube style) · Limebug · vendor-doc · retrieved 2026-11-04
  6. Fuel gauge sender unit (lever type): T2 Bus (1974-1979) · Heritage Parts Centre · vendor-doc · retrieved 2026-11-04
  7. T2 1968-79 Bay Window RHD speedo drive cable (2510 mm) · Limebug · vendor-doc · retrieved 2026-11-04
  8. VDO Royale speedometer 120 MPH 80 mm · Heritage Parts Centre · vendor-doc · retrieved 2026-11-04

Markets: Germany, USA, UK, Australia, Brazil, Mexico, South Africa. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.