Germany · 1955-1974 (Germany); 1962-1975 (Brazil) · VDO instruments

Volkswagen Karmann Ghia (Type 14) gauges

VDO instrumentsCable speedoClock hole often used for a tachFuel stabiliser 113 957 099 ASender changes 1960, 1967 and 197352 mm add-on pods

Karmann Ghia gauges are VDO round instruments shared in spirit with the Beetle: a large cable-driven speedometer with round clock and fuel gauge positions beside it on most years. Owners often put a 52 mm (2 1/16 in) tach in the clock hole. No parts source we found publishes the factory hole sizes, so measure before buying.Low123

3 gauges · 100 mm + 52 mm

A Round Gauge kit for the Volkswagen Karmann Ghia (Type 14)

Built from the factory gauge sizes below: one digital gauge per hole.

Factory gauges

3 round instruments in the factory dash

InstrumentOriginal sizeHow it worksRound Gauge
SpeedometerNot publishedLow2Cable drive100 mm To measurePlaceholder match. No source gives the speedometer opening; measure it.
ClockAbout 52 mm (2 1/16 in), owner-reportedLow1Clock52 mm To measureOwners report that 52 mm gauges fit the factory clock hole on 1967-1971 cars. Not confirmed by a parts catalogue.
Fuel gaugeNot publishedLow13Thermal (bimetal)52 mm To measurePlaceholder match. Owners have fitted 52 mm VDO gauges in the factory positions, but the original size is not published.

Electrical facts for a gauge swap

Earth polarity, stabiliser, senders and signal types.

System voltage6 V early cars, 12 V laterThe Ghia followed the Beetle's 6 V to 12 V change; confirm the year at the battery.Researched, unverified3
Fuel gauge stabiliserVW 113 957 099 AParuzzi lists it for Beetle from August 1967; check Ghia fitment by year.Sourced · medium3
Fuel sender

111 919 051 A (1955-1960), 271 919 051 B (1967-1973), 113 919 049 D (1973-1974)

Sourced · medium2
Speedometer drive
  • Mechanical cable
  • 141 957 801 C bayonet cable on 1972-1974 LHD
Sourced · medium2
Tach signalNo factory tachAdded tachs on points ignition read the coil; confirm with the tach maker.Researched, unverified1

The factory dash, with history and variants

The Type 14 Karmann Ghia was built in Osnabrück from 1955 to 1974 and in Brazil into the 1970s.

Its dash carries a large VDO speedometer with round clock and fuel gauge positions on most years.Low41

Early cars to 1966 use a chrome speedo trim ring, part 113 957 371. The 1972-1974 cars take a different bayonet-fit speedo cable, which marks the late dash.Medium2

How the original instruments work

The speedometer is mechanical and cable driven.

The fuel gauge reads a tank sender through the 113 957 099 A stabiliser, which steadies the supply against battery voltage.Medium23

The fuel sender changed with the tank. Parts lists show three senders across 1955-1960, 1967-1973 and 1973-1974, so match the sender to the car's year.Medium2

What owners replace and why

The clock hole is the usual home for a tach.

Owners also fit oil temperature, oil pressure and voltmeter gauges in 52 mm (2 1/16 in) VDO sizes using under-dash plates or column pods.Low132

Going digital without losing the look

A GPS or sensor-fed speedometer removes the cable, and a digital fuel gauge built for VW senders is already sold for these cars.

Keep the original sender if the new gauge reads its range.Medium2

Store the original speedometer, clock and trim rings. Use clamps or rings in the existing holes so the dash is never cut.Low2

Common faults with the original gauges

  1. 1Fuel gauge inaccurate

    Usual cause

    Wrong sender for the year or a failing stabiliser

    Fix

    Confirm the sender part for the year, then test the stabiliser.Low23

  2. 2Speedometer bounces

    Usual cause

    Worn or dry cable

    Fix

    Replace the cable for the correct year range.Low2

Restoration tips

Keep it original and reversible

  • Keep the year-correct trim ring; early cars use 113 957 371.Medium2
  • Mount added gauges under the dash or on the column so the original fascia stays uncut.Medium2

Frequently asked

What gauges does a Karmann Ghia have?

A Type 14 Karmann Ghia has a large VDO speedometer with round clock and fuel gauge positions on most years. There was no factory tach. Warning lights sit in or beside the speedometer, and layouts changed over the 1955-1974 run, so check your year.Low12

Can a tach go in the Karmann Ghia clock hole?

Yes, owners commonly fit a 52 mm (2 1/16 in) tach in the clock hole, reported for 1967-1971 cars. This is owner-reported rather than a published hole size, so measure the hole before buying. The tach usually takes its signal from the ignition coil.Low1

What fuel sender does a 1973 Karmann Ghia use?

Parts lists show 271 919 051 B for 1967-1973 and 113 919 049 D for 1973-1974. A 1973 car sits on the change, so check the tank and the existing sender before ordering.Medium2

Does the Karmann Ghia have a voltage stabiliser?

Yes, the electric fuel gauge uses VW stabiliser 113 957 099 A, the same part as the Beetle from August 1967. It keeps the gauge supply steady. A gauge that reads the sender directly may not need it.Medium3

What size gauges fit a Karmann Ghia?

Add-on gauges are usually 52 mm (2 1/16 in), sold in VDO sizes with Ghia-listed pods and brackets. The factory speedometer and clock openings are not published in the sources we found, so measure them before choosing a replacement.Medium23

Related cars

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Karmann Ghia three-gauge dash thread · TheSamba.com forum · community · retrieved 2026-11-04
  2. Karmann Ghia gauges, senders and speedo parts · Heritage Parts Centre · vendor-doc · retrieved 2026-11-04
  3. 957 dash instruments, Karmann Ghia · Paruzzi · vendor-doc · retrieved 2026-11-04
  4. Volkswagen Karmann Ghia · Wikipedia · reference · retrieved 2026-11-04

Markets: Germany, USA, UK, Brazil, Australia. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.