S2000 AP1: every channel it can give you
11 channels are already mapped from public vehicle data. 6 more chassis and driver channels are on the car, waiting for GAINS discovery. Plus 25 Hz GPS and a motion sensor in the dongle itself.

Channels
Every channel the AP1 is expected to give, by group. Filter by how it arrives.
Driver inputs
Wheels and chassis
Engine
Temperatures and pressures
Stability systems
Built into the dongle, on every car
How the data gets out
Where the AP1's sensors live and how GAINS reaches them.
Wired connection to the car's CAN bus
This car's OBD-II port uses an older protocol for engine data, but the stability-control, ABS and dash modules talk on an internal CAN bus. A two-wire connection to that bus lets discovery read the chassis sensors.
Telemetry Dongle Pro (engine data) · CAN tap lead for chassis data (accessory, coming later)Discovery on your S2000
The 6 channels marked “To discover” are learned once, from your car, then added for every AP1 owner.
- Plug in and identify
The dongle finds the bus speed by listening only, reads the VIN and matches the car's data pattern to our database.
about 1 min - Guided steps, parked
The app walks you through each control for a few seconds: wheel lock to lock, brake light then firm, throttle (engine off), clutch, every gear, handbrake, stability-control button. The dongle records what changes on the car's data stream.
about 5 min - Module read
With the car parked, the dongle asks each module (ABS, gearbox, body) which values it can report. Read-only requests: nothing is written or changed.
about 5–10 min, automatic - Short drive
A normal drive with a few stops, steady speeds and turns. The dongle matches unknown values against its 25 Hz GPS and motion sensor to find wheel speeds, yaw rate and g-forces.
10–15 min - Results
Matched channels appear in the app. Anything that needs a closer look is checked by us and added later; you get a notification, and every owner of the same car gets the channel too.
most right after the drive
First time: about 25–30 minutes, once per car. Times are estimates until measured on real cars. Discovery only listens and reads: it never writes to the car, clears codes or bypasses security.
Published CAN IDs
Community definitions for the AP1/AP2: expected values, not yet confirmed by our own logs.
Show 11 signals
| Channel | CAN ID | Start bit · length | Byte order | Scale · offset | Unit |
|---|---|---|---|---|---|
| Steering angle | 0xC6 | 7 · 16 (signed) | Motorola (BE) | 0.1 · 0 | deg |
| Lateral g | 0xC6 | 23 · 8 (signed) | Motorola (BE) | 0.1 · 0 | unknown |
| Accelerator pedal | 0xAA | 7 · 8 | Motorola (BE) | 0.392157 · 0 | % |
| Brake pressure | 0x6A | 47 · 16 | Motorola (BE) | 1 · 0 | raw |
| Engine RPM | 0x12C | 39 · 16 | Motorola (BE) | 1 · 0 | rpm |
| Coolant temperature | 0x12C | 7 · 8 | Motorola (BE) | 1 · -40 | degC |
| Intake air temperature | 0x12C | 15 · 8 | Motorola (BE) | 1 · -40 | degC |
| Wheel speed, front left | 0x1C0 | 7 · 15 | Motorola (BE) | 0.0098 · 0 | km/h |
| Wheel speed, front right | 0x1C0 | 8 · 15 | Motorola (BE) | 0.0098 · 0 | km/h |
| Wheel speed, rear left | 0x1C0 | 25 · 15 | Motorola (BE) | 0.0098 · 0 | km/h |
| Wheel speed, rear right | 0x1C0 | 42 · 15 | Motorola (BE) | 0.0098 · 0 | km/h |
Full details and sources: Honda S2000 data by year.
FAQ
Can I log steering angle and brake pressure on a S2000 AP1 through the OBD-II port?
Yes, expected on the data stream. A standard OBD2 scan tool won't show them because they aren't standard OBD2 values.
What OBD-II protocol does the S2000 AP1 use?
K-line (ISO 9141 / KWP2000).
How long does discovery take on a AP1?
The first time, about 25–30 minutes, once per car (estimate): guided steps while parked, a read-only module check and a short drive. After that the dongle recognises the car when you plug in.
Channel lists combine public vehicle data from the open-source community with the equipment this generation is known to carry. “Expected” and “To discover” channels are not yet confirmed by our own logs, and equipment varies by market, trim and year. Vehicle names identify the cars only; GAINS is not affiliated with Honda. Image: GAINS studio render. Specifications are pre-release and may change before launch.

