Dyno correction factor calculator (SAE J1349 and STD)

A dyno correction factor scales measured power to standard weather. SAE J1349 corrects to 25 °C and 99 kPa of dry air; the older STD (J607) to 60 °F and 29.92 inHg, so STD figures read about 4% higher.

psi
°F
%
hp

Result

SAE J1349 factor1.017 :1
STD (SAE J607) factor1.055 :1

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

CF(SAE J1349) = 1.18 × (99 ÷ Pd) × √((T + 273) ÷ 298) − 0.18;  CF(STD) = (29.92 ÷ Pd) × √((T°F + 460) ÷ 520)
  1. Subtract water vapor pressure (from temperature and humidity) from barometric pressure to get dry-air pressure.
  2. Apply the standard's formula; the SAE form includes a mechanical-efficiency term, which is why it has the 1.18 and −0.18.

Worked example

Inputs

Barometric pressure (absolute, not sea-level-corrected)
14.5 psi
Inlet air temperature
85 °F
Relative humidity
40 %
Observed power (optional)
0 hp

Result

SAE J1349 factor1.017:1
STD (SAE J607) factor1.055:1

Assumptions and limits

  • Use station (absolute) pressure, not the sea-level-adjusted pressure from weather reports.
  • Corrects for weather only; dyno type, tire pressure and ramp rate change readings too.

Related terms

Frequently asked

What is the difference between SAE and STD correction?

SAE J1349 corrects to 25 °C (77 °F) and 99 kPa of dry air and includes a mechanical-efficiency term. The older STD (SAE J607) corrects to 60 °F and 29.92 inHg dry. STD numbers come out about 4% higher than SAE from the same run.

Which dyno correction factor should I use?

Use SAE J1349 for comparisons with factory ratings and most published figures. What matters most is to use the same correction for every run you compare.

Should I use the weather report barometric pressure?

No. Weather reports adjust pressure to sea level. Dyno correction needs absolute (station) pressure where the engine is running, measured on site or calculated from altitude.

Answers draw on the sources below.

Sources

  1. SAE J1349: Engine Power Test Code - Spark Ignition and Compression Ignition - As Installed Net Power Rating · SAE International
  2. New equations for computing vapor pressure and enhancement factor (Buck, 1981) · Journal of Applied Meteorology 20(12)

Spot an error? Tell us.