United Kingdom · 1961-1974 · Smiths instruments

Jaguar E-Type (XK-E) Series 1, 2 and 3 gauges

5 in speedo and tach glass (Series 1)Tachometer generator on Series 1Center-panel small gaugesToggle switches to 1967, rockers afterNegative earth from the mid-1960sCable speedometer

Jaguar E-Type gauges are Smiths instruments: a large speedometer and tachometer in front of the driver, with 5 in (127 mm) glasses on the Series 1, plus small gauges in the center panel. The Series 1 tach works from a tachometer generator. Early cars are positive earth; Series 1 cars changed to negative earth with the alternator in the mid-1960s.Medium13

3 gauges · 115 mm + 52 mm

A Round Gauge kit for the Jaguar E-Type (XK-E) Series 1, 2 and 3

Built from the factory gauge sizes below: one digital gauge per hole.

Factory gauges

3 round instruments in the factory dash

InstrumentOriginal sizeHow it worksRound Gauge
Speedometer5 in (127 mm) glass, bezel and dash seal (Series 1)Medium1Cable drive115 mm With a ringThe 5 in instrument is larger than any Round Gauge size, so the 115 mm gauge would need a ring. Measure the opening.
Tachometer5 in (127 mm) glass, bezel and dash seal (Series 1)Medium12Other115 mm With a ringSeries 1 tach works from a tachometer generator, which Moss lists for the Series 1. Confirm the drive on later cars.
Small gauges in the center panelSmall Smiths gauges with their own Series 1 bezel; size not publishedLow1Other52 mm To measureMoss sells a Series 1 small-gauge bezel but no diameter. Confirm each gauge's function and measure each hole before planning a set.

Electrical facts for a gauge swap

Earth polarity, stabiliser, senders and signal types.

Earth polarity
  • Positive earth on early Series 1 cars
  • Negative earth with the alternator from the mid-1960s
Wikipedia places the change in the 1965-1967 Series 1 cars.Sourced · medium3
Tach driveTachometer generator on Series 1Sourced · medium21
Speedometer drive
  • Cable with an angle drive at the gearbox end
  • Cable lengths differ by body (OTS/FHC vs 2+2) and RHD/LHD
Sourced · medium1
Fuel and temperature sender rangesNot published in the E-Type sources we usedMeasure the senders before choosing digital gauges.Researched, unverified1

The factory dash and its variants

The Series 1 3.8 has an aluminium-trimmed center instrument panel with a row of metal toggle switches; the console changed to vinyl and leather from 1963. The large speedometer and tachometer sit in front of the driver.Medium31

US rules brought black rocker switches on the 1968 Series 1.5, and the Series 2 of 1968-1971 moved the ignition to the column. The Series 3 V12 ran from 1971 to 1974.Medium3

The gauge list here describes the Series 1 (1961-1967), where Moss publishes the 5 in glass, bezel and seal sizes for the big dials.Medium1

How the original instruments work

The speedometer is cable-driven through an angle drive.

Moss lists different cables for the 3.8, the 4.2 OTS and FHC, and the 4.2 2+2.Medium1

The Series 1 tach works from a tachometer generator, a separate part Moss lists for the Series 1, rather than from the coil.Medium2

Each big dial seals to the dash with a 5 in seal, and the glass is retained in the bezel with a cord in 2.5, 3 or 4 mm sizes.Medium1

What owners replace and why

Glasses, bezel cords and dash seals are the common consumables when instruments come out for restoration, and all are sold for the Series 1.Medium1

Owners also fit LED dash bulb kits, which Moss lists for Series 1, 2 and 3. Check the kit suits your car's earth polarity.Low13

Going digital without losing the look

The 5 in big dials are larger than common digital sizes, so a 115 mm (4.5 in) gauge needs a ring to fill the opening.

Measure the opening first.Medium1

The Series 1 tach generator signal is not the coil pulse most electronic tachs expect. Take a new signal from the coil negative or the ignition's tach output, and leave the generator in place.Low24

Early positive-earth cars need care, since many electronic gauges are negative-earth only. GPS speed avoids matching the cable and angle drive; keep the originals for a reversible fit.Medium34

Common faults with the original gauges

  1. 1Speedometer needle waves or stops

    Usual cause

    Worn cable or failing angle drive

    Fix

    Replace the cable for your body style and side, and check the angle drive at the gearbox.Low1

  2. 2Tach dead on a Series 1

    Usual cause

    Fault in the tachometer generator or its wiring

    Fix

    Check the generator and its connections before condemning the tach head; the generator is sold separately.Low2

  3. 3Dust or moisture behind the glass

    Usual cause

    Hardened dash seal or bezel cord

    Fix

    Replace the 5 in seal and the bezel cord when the instrument is out.Low1

Restoration tips

Keep it original and reversible

  • Keep Series 1 toggle-switch and later rocker-switch dashes distinct; the switch type dates the car.Medium3
  • Use the correct speedometer cable for your body (3.8, 4.2 OTS/FHC or 2+2) and drive side.Medium1
  • Replace glass cords and seals with the instrument out rather than forcing an old seal.Low1

Frequently asked

What size are Jaguar E-Type speedometer and tachometer?

Moss sells 5 in (127 mm) glasses, bezels and dash seals for the Series 1 speedometer and tachometer. The dash opening itself is not published, so measure it. A 5 in instrument is larger than most modern replacements, which then need a ring or cup.Medium1

How is the E-Type Series 1 tachometer driven?

It works from a tachometer generator, which Moss lists as a Series 1 part. A modern electronic tach normally reads the coil instead, so it needs its own signal wire, and the generator can be left in place for a reversible fit.Medium2

Is the E-Type positive or negative earth?

Early Series 1 cars are positive earth. Series 1 cars built from 1965 to 1967 changed to negative earth when the dynamo gave way to an alternator. Check your car's battery connection before fitting any electronic gauge, because many are built for negative earth only.Medium34

What changed on the E-Type dash for Series 2?

The 1968 Series 1.5 swapped the metal toggle switches for black rockers under US rules, and the Series 2 moved the ignition to a steering-column lock, replacing the dash starter button. The 3.8 cars also lost their aluminium center trim in 1963.Medium3

Related cars

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Jaguar E-Type dashboard and gauges · Moss Motors · vendor-doc · retrieved 2026-11-03
  2. Tachometer generator, Series I (XKE-7872) · Moss Motors · vendor-doc · retrieved 2026-11-03
  3. Jaguar E-Type · Wikipedia · reference · retrieved 2026-11-03
  4. Instructions for 80mm/100mm 12 volt Smiths Classic tachometer · Smiths Instruments (Caerbont) · vendor-doc · retrieved 2026-11-03

Markets: UK, USA, Canada, Europe, Australia. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.