United Kingdom · 1959-1967 · Smiths, Jaeger instruments

Austin-Healey 3000 (BN7, BT7, BJ7, BJ8) gauges

4 in speedo and tach glass52 mm dual oil and water gaugeBig dials in front of driver on BJ8Cable speedometer with angle driveOver 90% exported (1963)Polarity: check the battery

Austin-Healey 3000 gauges are Smiths instruments: a large speedometer and tachometer with 4 in (102 mm) glasses, plus small fuel and dual oil-pressure and water-temperature gauges. Suppliers list the BJ8 dual gauge at 52 mm (2.05 in). The Mk III BJ8 moved the speedometer and tachometer directly in front of the driver.Medium123

4 gauges · 100 mm + 52 mm

A Round Gauge kit for the Austin-Healey 3000 (BN7, BT7, BJ7, BJ8)

Built from the factory gauge sizes below: one digital gauge per hole.

Factory gauges

4 round instruments in the factory dash

InstrumentOriginal sizeHow it worksRound Gauge
Speedometer4 in (102 mm) glass-to-gauge seal, 100, 100/6 and 3000 (1960-67)Medium1Cable drive100 mm To measureThe 4 in glass seal points to a 100 mm class instrument, but the dash opening is not published. Measure it.
Tachometer4 in (102 mm) glass, same as the speedometerLow1Other100 mm To measureDrive type is not stated in the sources we used; look for a cable on the back of the head before planning the signal.
Oil pressure and water temperature (dual)52 mm (2.05 in) body, 56 mm (2.20 in) bezelMedium2Capillary (mechanical)52 mm Size matchListed for the BJ8; the oil side is a pressure line and the temperature side a capillary bulb.
Fuel gaugeSmall gauge; size not published for the 3000Low1Other52 mm To measureMoss lists a 2 in small-gauge bezel for the earlier 100 (BN1, BN2); confirm the 3000 size by measuring.

Electrical facts for a gauge swap

Earth polarity, stabiliser, senders and signal types.

Earth polarityNot confirmed in the 3000 sources we usedMany British cars of this age are positive earth. Check the battery before fitting electronic gauges, many of which are negative-earth only.Researched, unverified4
Speedometer driveCable with an angle drive at the gearboxSourced · medium1
Temperature gaugeCapillary bulb, part of the dual gaugeSourced · medium2
Fuel sender rangeNot published in the 3000 sources we usedMeasure the sender empty and full before choosing a digital gauge.Researched, unverified1

The factory dash and its variants

The 3000 ran from 1959 to 1967 as the two-seat BN7, the 2+2 BT7, the BJ7 convertible from 1962 and the BJ8 Mk III from 1964.

The BJ8 put the speedometer and tachometer directly in front of the driver.Medium3

Moss lists one 4 in glass-to-gauge seal for the 100, 100/6 and 3000, so the big-dial glass size carried through the range. The gauge list here describes the BJ8, where the dual gauge size is published.Medium12

How the original instruments work

The speedometer is cable-driven through an angle drive at the gearbox.

Moss sells both an original-style angle drive and a cheaper version listed for Austin-Healey, MGB, MGC and Triumph.Medium1

The dual gauge reads oil pressure through a pipe and coolant temperature through a sealed capillary to a bulb. The whole unit comes out together.Medium2

What owners replace and why

Glass seals, bezels and glass cords are the common consumables when instruments come out for restoration.Medium1

Worn angle drives cause erratic speedometer readings, and replacements are widely sold.Low1

Going digital without losing the look

The 4 in glass suggests a 100 mm class gauge for the speedometer and tachometer, but measure the dash opening before ordering.Medium1

GPS speed avoids matching the cable and angle drive. A digital tach usually reads the coil negative, so plan a signal wire if the original is cable-driven.Low14

Confirm the car's earth polarity first; the Smiths Classic tach, for example, is rated for negative earth only. Keep the originals for a reversible fit.Medium4

Common faults with the original gauges

  1. 1Speedometer needle waves or reads erratically

    Usual cause

    Worn angle drive or cable

    Fix

    Replace the angle drive and its washer, and check the cable.Low1

  2. 2Temperature gauge reads nothing

    Usual cause

    A broken or kinked capillary on the dual gauge

    Fix

    Replace or rebuild the dual gauge; the capillary cannot be spliced.Low2

Restoration tips

Keep it original and reversible

  • Replace the 4 in glass seal and bezel cord whenever a big dial comes out.Medium1
  • Keep the BJ8 driver-facing instrument layout distinct from the earlier cars when sourcing a dash.Low3

Frequently asked

What size are Austin-Healey 3000 speedometer and tachometer?

Moss lists a 4 in (102 mm) glass-to-gauge seal for the 100, 100/6 and 3000 from 1960 to 1967, which puts the big dials in the 100 mm class. The dash opening itself is not published, so measure it before ordering a replacement.Medium1

What size is the Austin-Healey dual oil and water gauge?

British Parts Northwest lists the BJ8 dual oil-pressure and water-temperature gauge with a 52 mm (2.05 in) body and a 56 mm (2.20 in) bezel. Oil pressure arrives through a pipe and temperature through a capillary bulb.Medium2

Did the BJ8 move the gauges?

Yes. The Mk III BJ8, announced in February 1964, placed the speedometer and tachometer directly in front of the driver. It stayed in production until the end of 1967.Medium3

Will a 100 mm speedometer fit an Austin-Healey 3000?

Probably, since the original glass is 4 in (102 mm), but no supplier we checked publishes the opening. Measure the hole across its center and compare it with the new gauge's body diameter, not its bezel, before buying.Low1

Related cars

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Austin-Healey 100, 100-6, 3000 dashboard and gauges · Moss Motors · vendor-doc · retrieved 2026-11-03
  2. Gauge, dual oil pressure / water temp, BJ8, MGA, MGB 63-67, Sprite, Midget · British Parts Northwest · vendor-doc · retrieved 2026-11-03
  3. Austin-Healey 3000 · Wikipedia · reference · retrieved 2026-11-03
  4. Instructions for 80mm/100mm 12 volt Smiths Classic tachometer · Smiths Instruments (Caerbont) · vendor-doc · retrieved 2026-11-03

Markets: USA, Canada, UK, Australia, Europe. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.