A Round Gauge kit for the MG MGA (1500, Twin Cam, 1600, 1600 Mk II)
Built from the factory gauge sizes below: one digital gauge per hole.
Factory gauges
4 round instruments in the factory dash
| Instrument | Original size | How it works | Round Gauge |
|---|---|---|---|
| SpeedometerSmiths SN.6104 / SN.6161 series | Large main dial; owners report a 4 in (100 mm) GPS speedometer fits the holeLow18 | Cable drive | 100 mm To measureNo supplier states the hole diameter. The 4 in fit is an owner report; measure first. |
| Tachometer | Same large dial as the speedometerMedium23 | Cable-driven tach | 100 mm To measureCable-driven from the engine. Five-main-bearing MGB engines have no tach drive, so engine swaps need an electric tach. |
| Oil pressure and water temperature (dual) | 52 mm (2.05 in) body, 56 mm (2.20 in) bezelMedium67 | Capillary (mechanical) | 52 mm Size matchMechanical oil line plus capillary temperature bulb in one case. |
| Fuel gauge | Small Smiths case alongside the dual gaugeLow4 | Moving iron / air-core | 52 mm To measureSize not published in the sources we used; it matches the small-gauge layout. Measure before ordering. |
Electrical facts for a gauge swap
Earth polarity, stabiliser, senders and signal types.
- Three-coil armature gauge
- Reading moves toward E as sender resistance falls toward zero
- Not fitted
- The BMC stabilizer arrived on the MGB from the 1965 model year
- Cable
- 1440 turns per mile with the standard 4.3:1 axle, 1325 to 1730 across optional ratios
The factory dash and its variants
The MGA dash puts a large speedometer and tachometer either side of the steering column, with small fuel and dual oil-and-water gauges. Faces read Jaeger on many cars and Smiths on others.Medium26
Speedometers changed from the Smiths SN.6104 series to SN.6161 in September 1958. Each axle ratio had its own unit, from 1325 turns per mile for the 3.9:1 axle to 1730 for the 5.125:1 Twin Cam option.Medium1
The gauge list here applies to all MGA models. The 1500, Twin Cam, 1600 and 1600 Mk II share the layout; the speedometer calibration is what changes.Medium13
How the original instruments work
The tachometer is mechanical, driven by a cable from the engine.
The speedometer is cable-driven from the gearbox.Medium23
The fuel gauge uses three coils and an armature. Lower sender resistance means more current and a reading toward E, the opposite of the later BMC thermal gauges.Medium4
Oil pressure reaches the dual gauge through a pipe, and coolant temperature through a sealed capillary to a bulb. The capillary and bulb cannot be separated from the gauge.Medium73
What owners replace and why
Engine swaps drive many tach changes.
A five-main-bearing MGB engine has no mechanical tach drive, so owners fit an electric tach such as the Smiths RVI2401 from the 1965-1967 MGB, which looks close to the original.Medium2
A wrong gear ratio after an axle change makes the speedometer read wrong, so owners swap the head for the matching turns-per-mile unit or recalibrate it.Medium1
Going digital without losing the look
An MGA has no electrical tach signal at the dash, because the original tach is cable-driven.
A digital tach needs a new wire from the coil negative, as the electric-tach conversion does.Medium2
GPS speed removes the turns-per-mile problem. Owners report a 4 in GPS speedometer fits the speedo hole, but the opening is not published, so measure it.Low81
Keeping the factory fuel sender only works if the new gauge suits the MGA coil-type sender. A gauge built for the later BMC stabilized range will read wrong.Low49
Positive earth is the other trap. Check that any electronic gauge accepts a positive-earth car, or convert the car first, and keep the originals for a reversible fit.Low52
Common faults with the original gauges
1Speedometer reads fast or slow
Usual causeThe head's turns-per-mile does not match the fitted axle ratio
FixFit the speedometer matching the axle (1440 tpm for 4.3:1) or have the head recalibrated.Medium1
2Temperature gauge reads nothing
Usual causeA broken or kinked capillary line, or an incorrect sender nut and bulb flange
FixCheck capillary routing and the bulb fitting; a broken capillary means rebuilding or replacing the dual gauge.Low3
3No tach after fitting an MGB five-bearing engine
Usual causeThat engine has no mechanical tach drive
FixFit an electric tach and wire it to the coil, observing the car's earth polarity.Medium2
Restoration tips
Keep it original and reversible
- Record the speedometer's BMC and Smiths numbers and its turns-per-mile; they tie the head to an axle ratio.Medium1
- An electric replacement tach may read Smiths where the original read Jaeger; keep the original for judging.Medium2
- Bleed the oil gauge line after any work so the needle responds properly.Low3
Frequently asked
Is the MGA tachometer mechanical?
Yes. The MGA tach is driven by a cable from the engine, not by an electrical signal. That matters for engine swaps: a five-main-bearing MGB engine has no tach drive, so owners fit an electric Smiths tach from a 1965-1967 MGB and wire it to the coil.Medium2
What turns-per-mile is an MGA speedometer?
With the standard 4.3:1 axle, the mph speedometer is 1440 turns per mile. Optional axles change it: 1325 for 3.9:1, 1376 for 4.1:1, 1536 for 4.555:1 and up to 1730 for the 5.125:1 Twin Cam ratio. The number is printed on the face.Medium1
Will a 4 inch GPS speedometer fit an MGA?
Owners report that a 4 in (100 mm) GPS speedometer fits the MGA speedo hole. No parts supplier publishes the hole diameter, so measure yours before buying. A GPS unit also avoids turns-per-mile matching, because it needs no cable.Low8
Why does my MGA fuel gauge read wrong?
The MGA gauge is a three-coil type that reads toward E as sender resistance falls, so a shorted wire shows empty. Check the sender wire and earths first. A sender from a later car with a different resistance range will also read wrong.Medium4
Related cars
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
9 sources
- ST-110 Speedometer models for MGA · The MGA With An Attitude (Barney Gaylord) · community · retrieved 2026-11-03
- DT-201 Changing to electric tachometer · The MGA With An Attitude (Barney Gaylord) · community · retrieved 2026-11-03
- Dash and instruments technical index · The MGA With An Attitude (Barney Gaylord) · community · retrieved 2026-11-03
- FG-101 Construction and operation of the MGA fuel gauge · The MGA With An Attitude (Barney Gaylord) · community · retrieved 2026-11-03
- ET-098 Why positive earth? · The MGA With An Attitude (Barney Gaylord) · community · retrieved 2026-11-03
- Gauge, dual oil pressure / water temp, MGA, MGB to 67 · British Parts Northwest · vendor-doc · retrieved 2026-11-03
- Oil/water gauge, Smiths replacement (361-761) · Moss Motors · vendor-doc · retrieved 2026-11-03
- GPS speedometer · The MG Experience MGA forum · community · retrieved 2026-11-03
- MGB voltage stabilizer tech tip · Chicagoland MG Club · community · retrieved 2026-11-03
Markets: UK, USA, Canada, Australia, Europe. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.

