Stoichiometric ratio

stoichstoichiometric AFRchemically correct mixturelambda 1

The stoichiometric ratio is the exact air-fuel ratio at which all the fuel and all the oxygen can react completely, leaving neither in excess. For typical gasoline it is about 14.7:1 by mass, for ethanol about 9:1 and for methanol about 6.5:1, and it corresponds to lambda 1.0 for any fuel.1239

How it works

The stoichiometric air-fuel ratio follows from chemistry.

Complete combustion turns each carbon atom into carbon dioxide and each pair of hydrogen atoms into water, which fixes how much oxygen, and therefore air, a fuel needs. Fuels that already contain oxygen, such as ethanol and methanol, need less air.31

Gasoline is a blend, so its stoichiometric ratio varies slightly with composition. Pure iso-octane is about 15.1:1, typical gasoline about 14.7:1, and blends containing oxygenates lower than that. An SAE study measured falling stoichiometric ratios as ethanol was added to gasoline.Medium24

Blends can be estimated by weighting each component's stoichiometric ratio by its mass fraction. That gives about 14.1:1 for E10 and about 9.8:1 for E85, assuming typical densities; the real value depends on the base gasoline and the actual ethanol content.Medium35

Typical values

Gasoline

14.7:1 by mass (pure iso-octane about 15.1:1; oxygenated pump gas lower)

Sourced92
E10about 14.1:1estimate, depends on base gasolineSourced · medium43
E85about 9.8:1estimate; pump E85 ranges from 51% to 83% ethanolSourced · medium83
Ethanol9.0:1Sourced9
Methanol6.47:1Sourced9
Dieselabout 14.5:1Sourced · medium9
Propane (LPG)15.67:1Sourced9
Methane (natural gas)
  • 17.23:1 for methane
  • Natural gas blends lower
Sourced · medium9
Hydrogen34.3:1Sourced9

In tuning

Stoichiometric operation is the emissions baseline.

A three-way catalyst oxidises CO and hydrocarbons and reduces NOx efficiently only in a narrow band around λ 1, so OEM closed-loop control dithers the mixture around stoichiometric at idle and cruise.36

Know which stoichiometric value your ECU and wideband assume. If either uses 14.7 while the fuel is E10 or E85, AFR numbers are offset even though lambda is correct. Working in lambda, and setting the fuel's stoichiometric value only where fuel mass must be calculated, avoids most errors.72

Formula and worked example

AFR_st,blend = Σ (w_i × AFR_st,i)
AFR_st,blend
stoichiometric air-fuel ratio of the blend
w_i
mass fraction of component i (fractions sum to 1)
AFR_st,i
stoichiometric air-fuel ratio of component i
3

Try it

:1
%

0 for E0 gasoline, 10 for E10, 85 for nominal E85.

Result

Lambda0.850 :1
Stoichiometric AFR of this blend14.70 :1

Planning estimate from the formula below, not a measurement.

Open the full afr to lambda converter →

Myths vs facts

Myth Stoichiometric is the best mixture for power.

Fact Peak power usually comes slightly rich of stoichiometric. Stoichiometric is chosen at cruise because the three-way catalyst needs it.3

Myth 14.7:1 applies to any pump gas.

Fact It is a nominal gasoline value. Ethanol blends are lower, about 14.1:1 for E10, so AFR readings assuming 14.7 are slightly off even when lambda is correct.Medium42

Frequently asked

What is the stoichiometric ratio?

It is the air-fuel ratio, by mass, that contains exactly enough air to burn all the fuel. Each fuel has its own value: about 14.7:1 for gasoline, 9:1 for ethanol and 6.47:1 for methanol. Lambda expresses any mixture relative to it, so λ 1.0 is stoichiometric on every fuel.923

What is the stoichiometric ratio of E85?

About 9.8:1 by mass for a blend containing 85% ethanol by volume, compared with about 14.7:1 for gasoline and about 9:1 for pure ethanol. Real E85 ranges from 51% to 83% ethanol by specification, so the actual stoichiometric ratio varies with the batch and season.Medium58

Why is gasoline's stoichiometric ratio 14.7:1?

It comes from the hydrogen-to-carbon ratio of typical gasoline. Burning each carbon and hydrogen atom to CO2 and water requires a fixed amount of oxygen, and air is only about 23% oxygen by mass, so roughly 14.7 kg of air is needed per kilogram of fuel.32

Why do cars run at stoichiometric?

The three-way catalytic converter can clean up CO, hydrocarbons and NOx at the same time only when the exhaust is close to stoichiometric. Engines therefore use oxygen-sensor feedback to hold λ 1 at idle and cruise, and leave it only for load, cold start or protection.36

What is the stoichiometric ratio of methanol?

About 6.5:1 by mass, versus about 9:1 for ethanol and about 14.7:1 for gasoline. Methanol therefore needs more than twice the fuel mass of gasoline for the same air, which drives very large injector and fuel-pump flow requirements on methanol-fueled engines.Medium1

Wiring, pinouts and parts

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

9 sources
  1. Stoichiometry (air-to-fuel ratio of common fuels) · Wikipedia · reference · retrieved 2026-10-25
  2. Air-fuel ratio · Wikipedia · reference · retrieved 2026-10-25
  3. Internal Combustion Engine Fundamentals, 2nd edition (2018) · McGraw-Hill (John B. Heywood) · book · retrieved 2026-10-25
  4. Elemental Composition Determination and Stoichiometric Air-Fuel Ratios of Gasoline Containing Ethanol (SAE 2010-01-2112) · SAE International · sae-paper · retrieved 2026-10-25
  5. US 7,789,063: System and method for engine air-fuel ratio control · US Patent and Trademark Office · reference · retrieved 2026-10-25
  6. Automotive Handbook, 10th edition (2018) · Robert Bosch GmbH / Wiley · book · retrieved 2026-10-25
  7. Lambda Sensor LSU 4.9 product page · Bosch Motorsport · vendor-doc · retrieved 2026-10-25
  8. E85 (flex fuel) specification · US DOE Alternative Fuels Data Center · oem · retrieved 2026-10-25
  9. Stoichiometry: table of stoichiometric air-fuel ratios of common fuels · Wikipedia · reference · retrieved 2026-10-27