Compression ratio calculator

Compression ratio = (swept volume + clearance volume) ÷ clearance volume, where clearance adds the chamber, gasket, deck height and piston dish or dome. Add rod length and intake closing to get dynamic compression.

mm
mm
cc
mm
mm
mm

Negative if the piston pops up above the deck.

cc

Dish and valve reliefs positive, dome negative.

mm
°

Result

Static compression ratio9.44 :1
Clearance volume59.2 cc
Swept volume per cylinder499.6 cc

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

CR = (V_swept + V_clearance) ÷ V_clearance;  V_clearance = chamber + gasket + deck + piston
  1. Swept volume per cylinder is π/4 × bore² × stroke.
  2. Gasket volume is π/4 × gasket bore² × compressed thickness; deck volume is π/4 × bore² × deck clearance.
  3. Dynamic compression uses only the stroke left after the intake valve closes, from the slider-crank geometry.

Worked example

Inputs

Bore
86 mm
Stroke
86 mm
Combustion chamber volume
50 cc
Gasket bore
87 mm
Gasket compressed thickness
0.7 mm
Piston below deck at TDC
0 mm
Piston dish volume
5 cc
Rod length (optional, for dynamic CR)
0 mm
Intake valve closing, degrees ABDC (optional)
0 °

Result

Static compression ratio9.44:1
Clearance volume59.2cc
Swept volume per cylinder499.6cc

Assumptions and limits

  • Dynamic CR depends on which cam timing figure you use (seat timing vs 0.050 in lift); compare like with like.

Related terms

Frequently asked

How do you calculate compression ratio?

Compression ratio = (swept volume + clearance volume) ÷ clearance volume. Clearance volume is the chamber plus head-gasket volume plus deck volume plus piston dish (minus dome).

What is dynamic compression ratio?

Dynamic compression ratio counts only the stroke left after the intake valve closes, because no compression happens while it is open. Later intake closing lowers dynamic compression, which affects cranking pressure and knock tendency.

How much does a thicker head gasket lower compression?

It depends on bore and chamber size. On an 86 mm bore with a 45 cc chamber, going from a 0.7 mm to a 1.3 mm gasket adds about 3.6 cc of clearance and lowers static compression by roughly 0.6-0.8 points. Use the calculator for your engine.

Answers draw on the sources below.

Sources

  1. Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018

Spot an error? Tell us.