United Kingdom · 1966-1973 · Smiths instruments

Triumph GT6 (Mk I, Mk II / GT6+, Mk III) gauges

Wood dash, full instrumentsCable tach and speedoBlack-rimmed gauges from Mk IISmiths fuel 150162, temp 15016310 V stabilizerHole sizes unpublished: measure

Triumph GT6 gauges are Smiths instruments in a wood dashboard: a cable-driven speedometer and tachometer plus fuel and water temperature gauges. The Mk II, sold as the GT6+ in North America, gained an anti-glare walnut finish and black-rimmed instruments. Suppliers do not publish the hole sizes, so measure before choosing replacements.Medium21

4 gauges · 100 mm + 52 mm

A Round Gauge kit for the Triumph GT6 (Mk I, Mk II / GT6+, Mk III)

Built from the factory gauge sizes below: one digital gauge per hole.

Factory gauges

4 round instruments in the factory dash

InstrumentOriginal sizeHow it worksRound Gauge
SpeedometerMain dial; size not publishedLow1Cable drive100 mm To measureMeasure the opening before ordering.
TachometerMain dial; size not publishedLow1Cable-driven tach100 mm To measureMoss sells GT6 tach and speedo cables, which points to a cable-driven tach on the cars it covers.
Fuel gauge150162Small Smiths gauge; size not publishedLow1Thermal (bimetal)52 mm To measure
Water temperature150163Small Smiths gauge; size not publishedLow1Thermal (bimetal)52 mm To measure

Electrical facts for a gauge swap

Earth polarity, stabiliser, senders and signal types.

Earth polarityNot confirmed in the GT6 sources we usedCheck the battery connection before wiring any electronic gauge; many modern units are negative-earth only.Researched, unverified4
Voltage stabilizer

Thermal fuel and temperature gauges on a stabilized supply of about 10 V average

Inferred from the Smiths thermal gauges fitted; Moss's GT6 page does not list a stabilizer.Researched, unverified31
Tach driveCableSourced · medium1
Speedometer drive
  • Cable
  • An angle drive is sold for Triumph gearboxes
Sourced · medium1

The factory dash and its variants

Every GT6 has a wood dashboard with a full set of instruments.

The Mk I ran from July 1966 to September 1968, the Mk II (GT6+ in North America) to December 1970, and the Mk III to December 1973.Medium2

The Mk II changed the look

An anti-glare walnut finish, black-rimmed instruments and rocker switches in place of chrome toggles. The gauge list here covers the speedometer, tachometer, fuel and temperature gauges common to all marks.Medium21

How the original instruments work

Both the speedometer and tachometer are driven by cables, which Moss lists for the GT6.

There is no electrical tach signal behind the dash.Medium1

The fuel and temperature gauges are Smiths thermal types. On cars of this family they run from a stabilizer that pulses battery voltage to about 10 V average.Low13

What owners replace and why

Moss lists the Smiths fuel and temperature gauges as low stock, so many owners repair the originals.Medium1

Noisy or bouncing needles usually come from dry or kinked cables, which are cheaper to replace than the heads.Low1

Going digital without losing the look

A digital tach needs a new signal wire from the coil negative, because the original is cable-driven.

GPS speed avoids matching the speedometer cable.Low14

Measure every opening first; no supplier we checked publishes GT6 gauge diameters. Feed digital gauges from a fused ignition supply and keep the originals for a reversible fit.Low13

Common faults with the original gauges

  1. 1Tach or speedo needle bounces

    Usual cause

    Dry, worn or kinked drive cable

    Fix

    Replace or lubricate the cable and route it without tight bends.Low1

  2. 2Fuel and temperature gauges read high together

    Usual cause

    A failed stabilizer passing full system voltage

    Fix

    Test the stabilizer output and replace it with the correct-polarity unit.Low3

Restoration tips

Keep it original and reversible

  • Mk I gauges have chrome rims and Mk II on black rims; keep the style that matches the car.Medium2
  • Leave the tach cable in place, capped, if you fit an electric tach.Low1

Frequently asked

Is the GT6 tachometer cable driven?

Yes, on the cars Moss covers it lists tach and speedometer cables for the GT6, so both instruments are driven mechanically. A digital tach needs a new signal wire from the ignition coil, and the cable can be left in place for a reversible fit.Low1

What gauges does a GT6 have?

A speedometer, a tachometer, and Smiths fuel and water temperature gauges, set in a wood dashboard. Moss lists the fuel gauge as 150162 and the temperature gauge as 150163. The Mk II and later cars have black-rimmed instruments.Medium12

Did GT6 gauges change between Mk I and Mk II?

The look changed. The Mk II, sold as the GT6+ in North America from July 1968, got black-rimmed instruments, an anti-glare walnut dash and rocker switches. The sources we used do not describe gauge changes for the Mk III.Medium2

What size are GT6 gauges?

The suppliers we checked do not publish GT6 gauge or hole diameters. Measure each opening across its center and the gauge body behind the bezel before buying replacements.Low1

Related cars

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Triumph GT6 dashboard and gauges · Moss Motors · vendor-doc · retrieved 2026-11-03
  2. Triumph GT6 · Wikipedia · reference · retrieved 2026-11-03
  3. MGB voltage stabilizer tech tip · Chicagoland MG Club · community · retrieved 2026-11-03
  4. Instructions for 80mm/100mm 12 volt Smiths Classic tachometer · Smiths Instruments (Caerbont) · vendor-doc · retrieved 2026-11-03

Markets: UK, USA, Canada, Europe, Australia. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.