United Kingdom · 1962-1980 · Smiths instruments

Triumph Spitfire (Mk I to 1500) gauges

Center dash Mk I to Mk IIIDriver-side dash Mk IV and 1500RVC2414 tach on 1975-on 150010 V stabilizerHole sizes unpublished: measureThree Moss gauge groups

Triumph Spitfire gauges are Smiths instruments that moved during the run. Mk I to Mk III cars have a center-mounted cluster, and the Mk IV and 1500 put the instruments in front of the driver. Each layout has a speedometer, tachometer, fuel and temperature gauge. Suppliers do not publish the hole sizes, so measure before choosing replacements.Medium31

4 gauges · 80 mm + 52 mm

A Round Gauge kit for the Triumph Spitfire (Mk I to 1500)

Built from the factory gauge sizes below: one digital gauge per hole.

Factory gauges

4 round instruments in the factory dash

InstrumentOriginal sizeHow it worksRound Gauge
Speedometer209540, 110 mph (Mk I, Mk II)Main dial; size not publishedLow1Cable drive80 mm To measureMeasure the opening; no supplier we checked lists a diameter.
Tachometer209543 (Mk I)Main dial; size not publishedLow1Other80 mm To measureThe drive type of the Mk I tach is not stated in the sources we used. The 1500 from 1975 uses a Smiths RVC2414 electric tach.
Fuel gauge147604 (Mk II, Mk III)Small gauge with chrome bezel; size not publishedLow12Thermal (bimetal)52 mm To measure
Water temperature134243 (Mk I, Mk II)Small gauge; size not publishedLow12Thermal (bimetal)52 mm To measure

Electrical facts for a gauge swap

Earth polarity, stabiliser, senders and signal types.

Earth polarity

Negative earth on the cars Moss lists the negative-ground stabilizer for

The sources we used do not give a polarity changeover for early Spitfires. Check the battery connection.Researched, unverified2
Voltage stabilizer
  • Yes
  • Feeds the thermal fuel and temperature gauges at about 10 V average
Sourced · medium24
Tach triggerVoltage-triggered Smiths RVC2414 on the 1500 from 1975Sourced · medium1
Fuel sender rangeNot published in the Spitfire sources we usedMeasure the sender empty and full before choosing a digital gauge.Researched, unverified1
Speedometer driveCable from the gearboxSourced · medium1

The factory dash and its variants

Spitfire Mk I to Mk III cars carry their instruments in the center of the dash.

US cars from 1969 moved the panel in front of the driver with a matte black finish.Medium3

The Mk IV of 1970 put the instruments in front of the driver on a full-width dash, black plastic at first and wood from 1973. The 1500 kept that layout, and from 1977 moved minor controls to column stalks.Medium3

Moss groups the gauges three ways

Mk I-III, Mk IV and 1500 through 1976, and 1500 from 1977. The gauge list here describes the Mk I-II center dash, where Moss publishes the most part numbers.Medium1

How the original instruments work

Fuel and temperature gauges are thermal types fed by a voltage stabilizer.

It pulses battery voltage to about 10 V average, and the bimetal gauges respond slowly enough to smooth it.Medium42

The speedometer is cable-driven. On the 1500 from 1975, the tachometer is a Smiths RVC2414, an electric unit that reads ignition pulses.Medium1

What owners replace and why

Original speedometer and tachometer assemblies are still sold for the Mk I, Mk II and Mk IV, but several are listed as low stock or back order.Medium1

Stabilizer failure is common on aging cars, and solid-state negative-ground replacements are sold for the Spitfire.Medium2

Going digital without losing the look

Measure the openings first, because no supplier we checked publishes Spitfire hole sizes.

The center and driver-side dashes differ, so a gauge set for one does not follow for the other.Medium13

On RVC-equipped cars the tach signal comes from the coil negative, which most electronic tachs also use. GPS speed avoids matching the cable drive.Low15

Feed digital gauges from a fused ignition supply, not the pulsing stabilizer. Keep the original gauges and senders for a reversible fit.Medium4

Common faults with the original gauges

  1. 1Fuel and temperature gauges read high together

    Usual cause

    A failed voltage stabilizer passing full system voltage

    Fix

    Replace the stabilizer with the correct-polarity unit.Low24

  2. 2Fuel gauge reads low or dead

    Usual cause

    Poor stabilizer earth or tank earth

    Fix

    Clean and tighten the stabilizer mounting, check the tank earth, then earth the gauge signal wire to test the gauge.Low4

  3. 3Wrong gauges after a dash swap

    Usual cause

    Mk I-III, Mk IV/1500 to 1976 and 1500 from 1977 use different gauge groups

    Fix

    Match gauges to the dash version and chassis number in the parts list.Medium1

Restoration tips

Keep it original and reversible

  • Keep the gauge set that matches the dash version; Moss lists separate groups for Mk I-III, Mk IV and late 1500.Medium1
  • Note the speedometer's top speed and part number before removal; the Mk I and Mk II unit reads to 110 mph.Medium1
  • Keep the original stabilizer polarity matched to the car.Medium2

Frequently asked

Where are the gauges on a Spitfire Mk3?

In the center of the dash on most Mk III cars, in a wood-veneer surround. US federal cars from 1969 moved the panel in front of the driver with a matte black finish. Every Spitfire from the Mk IV on has the instruments in front of the driver.Medium3

What tachometer does a Spitfire 1500 use?

Moss lists the Smiths RVC2414 tachometer for the Spitfire 1500 from 1975. It is an electric tach that takes its signal from the ignition. Earlier cars use different assemblies, such as 218835 on the Mk IV from FH50001.Medium1

Does the Spitfire have a voltage stabilizer?

Yes. The thermal fuel and temperature gauges run from a stabilizer that pulses battery voltage to about 10 V average. Moss sells a solid-state negative-ground replacement listed for the Spitfire and other British cars of the period.Medium24

What size are Spitfire gauges?

The parts suppliers we checked do not publish Spitfire gauge or hole diameters. Measure the opening across its center and the gauge body behind the bezel before buying anything. The center-dash and driver-side dashes need checking separately.Low1

Related cars

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Triumph Spitfire dashboard and gauges · Moss Motors · vendor-doc · retrieved 2026-11-03
  2. Solid state voltage stabilizer, negative ground (131-555), listed on the TR250/TR6 gauges page · Moss Motors · vendor-doc · retrieved 2026-11-03
  3. Triumph Spitfire · Wikipedia · reference · retrieved 2026-11-03
  4. MGB voltage stabilizer tech tip · Chicagoland MG Club · community · retrieved 2026-11-03
  5. Instructions for 80mm/100mm 12 volt Smiths Classic tachometer · Smiths Instruments (Caerbont) · vendor-doc · retrieved 2026-11-03

Markets: UK, USA, Canada, Europe, Australia. Make and model names identify the vehicle only; GAINS is not affiliated with the vehicle or instrument makers.