Fuel temperature compensation

fuel temp correctionfuel temperature correctionfuel density compensationhot fuel compensationfuel temperature trim

Fuel temperature compensation is an ECU correction that adjusts injected fuel as fuel temperature changes. Hot fuel is less dense, so the same injector pulse delivers less mass; very hot fuel can also start to vaporize in the rail. A fuel temperature sensor or model lets the ECU add fuel to hold the target mixture.Medium123

How it works

Injectors meter fuel by volume over time: flow depends on the orifice, pressure difference and pulse length.

Engines need fuel by mass. Liquid fuel expands as it warms, so each cubic centimeter carries less mass, and a fixed pulse delivers slightly leaner mixtures as fuel heats up.Medium12

Heat soak makes the problem worse after a hot shutdown. Fuel sitting in the rail near the engine warms, and if its temperature passes the point where vapor forms at rail pressure, bubbles displace liquid. That is vapor lock in older systems and a hot-restart lean condition in injected ones.Medium34

Injector makers set fuel temperature limits. Bosch's EV 14 data sheet, for example, gives a permissible fuel temperature of 70 °C (158 °F) or below. Return-style systems that recirculate a lot of fuel through a hot engine bay can push tank and rail temperatures up during long sessions.51

In tuning

If logs show lean drift late in a session or after hot restarts while airflow and targets are unchanged, check fuel temperature.

A sensor in the rail or return line plus a small correction table usually beats retuning the main fuel table for one temperature.Medium13

Reduce the heat first. Insulate or reroute lines away from exhaust, cut unnecessary recirculation with pump speed control or a returnless layout, and keep fuel pressure high enough to suppress vapor. Compensation then covers the residual change.Medium31

Myths vs facts

Myth Fuel temperature does not matter because closed loop corrects it.

Fact Closed-loop trim can mask the error at cruise, but open-loop regions such as full load and cold or hot starts rely on the base calculation. A known fuel temperature effect is better compensated directly.Medium1

Myth Hot fuel only matters on race cars.

Fact Hot-restart problems and vapor formation affect road cars too, especially in hot climates with high-volatility fuel. Fuel volatility specifications change with season partly for this reason.Medium43

Frequently asked

Why does hot fuel run lean?

Warm fuel is less dense, so an injector that meters a set volume delivers less fuel mass. Very hot fuel can also form vapor bubbles in the rail, which take up space the liquid should fill. Both effects lean the mixture unless the ECU adds fuel to compensate.Medium13

Do I need a fuel temperature sensor?

Not always. Many road cars run fine without one. A sensor helps when fuel temperature varies a lot: long track sessions, return systems in hot engine bays, ethanol blends or hard hot-restart problems. It also gives a logged channel that proves whether fuel heating explains a lean drift.Low13

What is hot restart enrichment?

It is a temporary fuel increase after restarting a heat-soaked engine. Fuel in the rail may have warmed or partly vaporized while the engine was off, so the first seconds of running need extra fuel until cooler fuel arrives from the tank. ECUs often scale it with coolant or fuel temperature.Medium13

How hot should fuel get?

As cool as practical, and within the injector and pump makers' limits. Bosch lists a permissible fuel temperature of 70 °C (158 °F) or below for its EV 14 injectors. Log fuel temperature during the hottest sessions to see how close the system runs to that limit.5

Wiring, pinouts and parts

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Automotive Handbook, 10th edition (2018) · Robert Bosch GmbH / Wiley · book · retrieved 2026-10-27
  2. Gasoline · Wikipedia · reference · retrieved 2026-10-27
  3. Vapor lock · Wikipedia · reference · retrieved 2026-10-27
  4. Reid vapor pressure · Wikipedia · reference · retrieved 2026-10-27
  5. Injection Valve EV 14 data sheet · Bosch Motorsport · vendor-doc · retrieved 2026-10-27