Warm-up enrichment

WUEcold start enrichmentafter-start enrichmentcranking enrichmentcoolant temperature correction

Warm-up enrichment is the extra fuel an ECU adds while an engine is below normal operating temperature, scheduled mainly by coolant temperature. It compensates for poor fuel vaporisation and wall-film losses on cold surfaces, and fades out as the engine warms.12

How it works

Cold engines evaporate fuel poorly.

A Southwest Research Institute patent notes that only about 10% of gasoline's components are volatile enough to evaporate at 20 to 30 °C (68 to 86 °F). The rest stays liquid on cold port and cylinder walls, so extra fuel is injected to reach a combustible vapour mixture.Medium31

Enrichment is usually split into stages

Cranking fuel, an after-start boost that decays over seconds, and a coolant-based warm-up correction that falls to zero at operating temperature. Closed-loop lambda control stays off until the sensor is ready.Medium14

This period dominates emissions. The same patent states about 60% to 80% of tailpipe hydrocarbons on the FTP-75 test come in the first 60 to 120 seconds after a cold start, before the catalyst lights off. SAE work showed finer fuel sprays and prevaporised fuel reduce the enrichment needed.Medium352

In tuning

Tune warm-up from fully cold soaks at several ambient temperatures, logging coolant, lambda and engine speed.

Too little fuel causes stalling and hesitation; too much causes rough running, plug fouling and fuel diluting the oil. Aim for the leanest mixture that runs cleanly.Medium12

Fuel blend changes the requirement. High-ethanol fuels vaporise poorly when cold and need substantially more cold enrichment, so flex calibrations blend warm-up tables by ethanol content.Medium671

Try it

:1
%

0 for E0 gasoline, 10 for E10, 85 for nominal E85.

Result

Lambda0.850 :1
Stoichiometric AFR of this blend14.70 :1

Planning estimate from the formula below, not a measurement.

Open the full afr to lambda converter →

Myths vs facts

Myth More cold-start fuel is always safer.

Fact Excess fuel washes oil off cylinder walls, dilutes the oil, fouls plugs and raises emissions. The target is the minimum that runs smoothly.Medium12

Myth Warm-up enrichment only depends on coolant temperature.

Fact Air temperature, time since start, fuel blend and load also matter. Most ECUs combine several corrections.Medium14

Frequently asked

Why do engines need extra fuel when cold?

Cold surfaces prevent much of the fuel from evaporating, and only vapour burns. More fuel is injected so enough vaporises to form a combustible mixture, with the rest forming a film on walls. As surfaces warm, more fuel evaporates and the enrichment is reduced.31

How long does warm-up enrichment last?

It tapers with coolant temperature and usually reaches zero at normal operating temperature. After-start enrichment decays faster, typically over seconds to tens of seconds once the engine is running. The overall time depends on ambient temperature, engine design, fuel blend and load during warm-up.Medium14

Why does my engine smell rich when cold?

Some richness during warm-up is normal because extra fuel is added and the catalyst is not yet working. If the smell continues after warm-up, check the coolant temperature sensor, since a sensor reading cold keeps enrichment active and can hold the engine out of closed loop.Medium13

Why is E85 harder to start in the cold?

Ethanol lacks gasoline's light, volatile components and has a high heat of vaporisation, so even less evaporates on cold surfaces. Winter E85 contains more gasoline for this reason, and flex-fuel calibrations add more cranking and warm-up fuel as measured ethanol content rises.Medium71

Wiring, pinouts and parts

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Internal Combustion Engine Fundamentals, 2nd edition (2018) · McGraw-Hill (John B. Heywood) · book · retrieved 2026-10-25
  2. Cold Start Performance of an Automotive Engine Using Prevaporized Gasoline (SAE 930710) · SAE International · sae-paper · retrieved 2026-10-25
  3. US 6,832,472: Method and apparatus for controlling exhausted gas emissions during cold-start of an internal combustion engine · US Patent and Trademark Office (Southwest Research Institute) · reference · retrieved 2026-10-25
  4. Automotive Handbook, 10th edition (2018) · Robert Bosch GmbH / Wiley · book · retrieved 2026-10-25
  5. Effects of Fuel Atomization, Vaporization, and Mixing on the Cold-Start UHC Emissions of a Contemporary S.I. Engine with Intake-Manifold Injection (SAE 952482) · SAE International · sae-paper · retrieved 2026-10-25
  6. Flex fuel sensors · Clemson University Vehicular Electronics Laboratory · reference · retrieved 2026-10-25
  7. E85 (flex fuel) specification · US DOE Alternative Fuels Data Center · oem · retrieved 2026-10-25