Sensor type · NTC thermistor

Coolant temperature sensor

ECT sensorCTSwater temp sensorengine coolant temperature sensor

A coolant temperature (CLT or ECT) sensor is an NTC thermistor in the water jacket. The ECU reads it through a pull-up resistor and uses it for warm-up enrichment, idle, ignition trims and fan control. Bosch's NTC M12 measures 2.5 kΩ at 20 °C and 187 Ω at 100 °C.21

Parts in the library

Support across ECUs

Across the 3 parts in this hub (2 with a maker-verified pinout). Open a part for the setup notes and sources.

GAINS ECU23 configurable (generic input)
Haltech (Elite / Nexus)3 configurable (generic input)
Link (G4X)3 configurable (generic input)
MoTeC (M1)1 preset listed · 2 configurable (generic input)
ECUMaster (EMU Black)3 configurable (generic input)
AEM (Infinity)3 configurable (generic input)
MaxxECU3 configurable (generic input)
Holley (Terminator X / EFI)3 configurable (generic input)

Trademarks belong to their owners. Names are used only to identify compatible products; no endorsement is implied.

How it works

Resistance falls steeply with temperature, so the ECU uses a table rather than a straight line. A pull-up of 1-3 kΩ centres resolution in the warm range where the engine spends most time.2

Coolant temperature changes slowly, so a sensor's response time matters less here than for intake air.Medium3

Types and variants

Two-wire ECU sensorNTC thermistor

Isolated signal and ground: the ECU's own sensor ground, best for accuracy.2

One-wire gauge senderNTC thermistor

Grounds through the engine block and drives a dash gauge; ground offsets make it a poor ECU input.Medium1

Wiring

Wire signal to an analog input with its pull-up on and the second pin to sensor ground. Torque the sensor to the maker's figure (25 N·m for the Bosch NTC M12).2

Fit the sensor where coolant flows with the engine cold and warm, typically near the thermostat housing or head outlet.Medium1

Connector and wiring library

Common faults and checks

Hard hot starts and rich running when warm

Likely cause Sensor reads colder than real (high resistance, corroded pin)

Check Measure resistance at operating temperature and compare to the maker's table.Medium2

Fans never switch on

Likely cause Open circuit makes the ECU see the coldest value

Check Check the reading changes when the connector is unplugged and reconnected.Medium1

Frequently asked

What resistance should a coolant temp sensor read?

It depends on the sensor. Bosch's NTC M12 reads 5,896 Ω at 0 °C, 2,500 Ω at 20 °C and 187 Ω at 100 °C. Use the table for your exact part number.2

Can I use the gauge sender for the ECU?

Not reliably. A single-wire gauge sender grounds through the block, so ground offsets shift the reading. Use a two-wire sensor on the ECU's sensor ground.Medium1

What pull-up resistor suits a coolant sensor?

Bosch suggests 1 or 3 kΩ for its NTC sensors. The value sets where in the temperature range the ECU has the best resolution.2

Related

Use it with GAINS

Coolant temperature sensor on GAINS hardware

ECU2AVI (thermistor, pull-up on)

Pins
On the ECU2 pin map
Pull-up
On
Shielding
Not needed

The K20 drive-by-wire example puts coolant on AVI5, pin 14.Medium4

GAINS hardware is pre-release concept design. Pin numbers come from the ECU2 v0.3 pin map and the PDM2 specification and can change before release; none of it has been tested on a vehicle yet.45

Concept Pre-release hardware. Pin assignments come from the current design documents and may change.

Sources

  1. Automotive Handbook, 10th edition (2018) · Robert Bosch GmbH / Wiley · book · retrieved 2026-10-27
  2. Temperature Sensor NTC M12 data sheet 70101387 · Bosch Motorsport (Bosch Engineering GmbH) · vendor-doc · retrieved 2026-10-27
  3. Dialing in LS sensors for various generations with Michigan Motorsports · EngineLabs · press · retrieved 2026-10-27
  4. internal GAINS internal: ECU2 concept and pin map v0.3 (hardware/mini-ecu/CONCEPT.md §3)
  5. internal GAINS internal: PDM2 input and output specification (hardware/mini-pdm/SPEC.md)

Not yet indexed: fewer than 4 FAQs.