Intake runner length calculator (approximate quarter-wave tuning)

Approximate tuned runner length = speed of sound × valve-closed time ÷ (4 × harmonic) − half the runner diameter. Enter the rpm to tune for, intake duration and air temperature to get a starting length. It is an approximate wave model, not a simulation.

rpm
°
°

Empirical allowance added to the closed period in common tuned-length formulas.

°F
in

Result

Tuned length, plenum to valve (approx.)13.1 in
2nd harmonic length20.1 in
3rd harmonic length13.1 in
4th harmonic length9.6 in
Speed of sound (ft/s)1,139
Valve-closed time12.31 ms

Approximate quarter-wave model: real runners also depend on plenum volume, taper, port length and cylinder interaction. Confirm on the dyno or with an engine simulation.

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

ECD = 720 − duration + allowance;  t = ECD ÷ (6 × rpm);  c = √(1.4 × 1716.5 × T_R) ft/s;  L = c × t × 12 ÷ (4 n) − D ÷ 2 (inches)
  1. When the intake valve closes, the moving air column creates a pressure wave that travels to the open end of the runner and reflects back.
  2. In a quarter-wave model the wave covers four runner lengths per oscillation; tuning places a returning high-pressure wave at the valve as it opens.
  3. The closed time comes from the crank degrees the valve is shut, and the wave speed is the speed of sound at the intake temperature.
  4. Shorter harmonics give practical lengths; half the diameter is subtracted as the open-end correction.

Worked example

Inputs

Engine speed to tune for
6500 rpm
Intake duration (seat or advertised)
270 °
Valve-closing allowance
30 °
Intake air temperature
80 °F
Runner inside diameter
1.75 in
Harmonic
3

Result

Tuned length, plenum to valve (approx.)13.1in
2nd harmonic length20.1in
3rd harmonic length13.1in
4th harmonic length9.6in
Speed of sound (ft/s)1139
Valve-closed time12.31ms

Assumptions and limits

  • Labelled approximate: one-dimensional wave, no flow velocity, no plenum or port interaction.
  • Length is measured along the centreline from the runner's open end (bellmouth) to the valve, including the port.
  • The valve-closing allowance is an empirical figure from common tuned-length formulas.

Related terms

Frequently asked

How long should intake runners be?

As a rough guide, longer runners tune lower in the rpm range and shorter ones higher. The quarter-wave estimate gives a starting length for a target rpm and cam, which you then confirm on the dyno or in a simulation.

Which harmonic should I use?

The 2nd harmonic gives very long runners that rarely fit; the 3rd and 4th are more practical for most engines. The stronger, lower harmonics give larger pressure pulses but need more length.

Is intake runner length measured to the valve?

Yes. The tuned length runs along the centreline from the open end (bellmouth or plenum entry) to the back of the intake valve, including the cylinder-head port.

Answers draw on the sources below.

Sources

  1. Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
  2. Design and Simulation of Four-Stroke Engines (unsteady gas dynamics in intake and exhaust ducts) · G. P. Blair, SAE International, 1999

Spot an error? Tell us.