Cam timing calculator: lobe separation, centerline and overlap
Intake centerline = (180 + IVC − IVO) ÷ 2 and lobe separation angle = average of the intake and exhaust centerlines. Enter the four valve events from a cam card to get duration, centerlines, LSA, overlap and the installed advance.
Result
Planning estimate from the formula below, not a measurement.
How it works
The formula, the method step by step, then a worked example.
duration = open + 180 + close; ICL = (180 + IVC − IVO) ÷ 2 ATDC; ECL = (180 + EVO − EVC) ÷ 2 BTDC; LSA = (ICL + ECL) ÷ 2; overlap = IVO + EVC; advance = LSA − ICL
- Duration is the opening point before the dead centre, plus the 180° between TDC and BDC, plus the closing point after it.
- Each lobe's centreline is its point of maximum lift: half the duration past the opening point.
- Lobe separation is the average of the intake and exhaust centrelines, in cam degrees.
- If the intake centreline is smaller than the LSA, the cam is installed advanced by the difference.
Worked example
Inputs
- Intake opens (° BTDC)
- 6 °
- Intake closes (° ABDC)
- 38 °
- Exhaust opens (° BBDC)
- 49 °
- Exhaust closes (° ATDC)
- 1 °
Result
Assumptions and limits
- All four events at the same checking lift (0.050 in tappet lift is the common US figure; seat timing gives larger durations).
- Symmetric lobes; asymmetric profiles shift the true peak-lift point slightly.
- Crank degrees throughout, which is how cam cards list events; LSA is conventionally quoted in cam degrees with the same number.
Related terms
Frequently asked
How do you calculate lobe separation angle?
Find each lobe's centreline from its opening and closing points, then average them. Intake centreline = (180 + intake closing ABDC − intake opening BTDC) ÷ 2; exhaust centreline = (180 + exhaust opening BBDC − exhaust closing ATDC) ÷ 2. LSA = (intake centreline + exhaust centreline) ÷ 2.
What does it mean if the intake centerline is less than the LSA?
The cam is advanced by the difference. A cam with a 110° LSA installed at a 106° intake centreline is 4° advanced, which opens and closes the intake valve earlier.
How do I calculate valve overlap?
Overlap is intake opening (° BTDC) plus exhaust closing (° ATDC), at the same checking lift. Equivalently, the average of the two durations minus twice the LSA. Overlap at 0.050 in lift is much smaller than at seat timing.
Answers draw on the sources below.
Sources
- Back To Basics: Understanding A Cam Card With Erson Cams (J. Smith, 2020) · EngineLabs · retrieved 2026-10-27
- Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
Spot an error? Tell us.

