Rod ratio calculator

Rod ratio = connecting rod length (centre to centre) ÷ stroke. Enter rod length, stroke and rpm to get the ratio, rod angle, and peak piston speed and acceleration, which rise as the ratio gets smaller.

mm
mm
rpm

Result

Rod ratio (rod ÷ stroke)1.663 :1
Peak piston acceleration at TDC (m/s²)39,254 4003 g
Piston acceleration at BDC (m/s²)21,104
Peak piston speed (m/s)37.6 at 74.5° ATDC
Mean piston speed (m/s)22.9
Maximum rod angle17.5 °

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

rod ratio = L ÷ S;  a(TDC) = r ω² (1 + r/L);  a(BDC) = r ω² (1 − r/L);  r = S/2, ω = 2π × rpm ÷ 60
  1. Rod ratio is rod length divided by stroke (Heywood's R uses crank radius, so it is twice this number).
  2. Slider-crank geometry gives piston position, speed and acceleration at every crank angle.
  3. Acceleration peaks at top dead centre, where it is r ω² (1 + r/L): a shorter rod relative to stroke raises it and lengthens the dwell at BDC.
  4. Peak piston speed is found by stepping through the crank angle.

Worked example

Inputs

Rod length (centre to centre)
143 mm
Stroke
86 mm
Engine speed
8000 rpm

Result

Rod ratio (rod ÷ stroke)1.663:1
Peak piston acceleration at TDC (m/s²)39254
Piston acceleration at BDC (m/s²)21104
Peak piston speed (m/s)37.6
Mean piston speed (m/s)22.9
Maximum rod angle17.5°

Assumptions and limits

  • No wrist-pin offset; offset pins change the numbers slightly.
  • Rigid parts at constant crank speed.
  • Geometry only: it says nothing about power, which depends on the whole engine.

Related terms

Frequently asked

What is a good rod ratio?

Most production engines fall between about 1.5 and 1.9 (rod length ÷ stroke). Higher ratios lower peak piston acceleration and side load; lower ratios make a shorter, lighter engine. There is no single best value; it is one trade-off among many in an engine design.

How do you calculate rod ratio?

Divide connecting-rod length, measured centre to centre, by the stroke. A 143 mm rod on an 86 mm stroke is 143 ÷ 86 = 1.66. Some textbooks use rod length ÷ crank radius instead, which is twice this number.

Does rod ratio change piston acceleration?

Yes. Peak acceleration at top dead centre is r ω² (1 + r ÷ L), so a shorter rod relative to stroke raises it. At 8,000 rpm with an 86 mm stroke and 143 mm rod it is about 39,000 m/s², roughly 4,000 g.

Answers draw on the sources below.

Sources

  1. Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
  2. 2.61 Internal Combustion Engines (lecture notes: engine geometry, performance parameters, specific fuel consumption) · MIT OpenCourseWare
  3. Automotive Handbook · Robert Bosch GmbH

Spot an error? Tell us.