Header primary length and diameter calculator (approximate)

A common rule of thumb gives header primary length = 850 × (180 + exhaust opening ° BBDC) ÷ rpm − 3 inches, with the diameter from cylinder volume and rpm. Enter cam timing, rpm and cylinder size for a starting length and inside diameter.

°

Seat-timing (advertised) figure from the cam card.

rpm
cc

Result

Primary length, valve to collector (approx.)29.7 in
Primary inside diameter (Bell rule)1.64 in
Primary inside diameter (area rule)1.69 in
Exhaust degrees (180 + EVO)250 °

Approximate rules of thumb: collector size, merge design, port length and cam timing all shift the result. Confirm with an engine simulation or on the dyno.

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

P = 850 × ED ÷ rpm − 3 (in), ED = 180 + EVO;  ID = 2.1 × √(cc ÷ ((P + 3) × 25)) (Bell);  A = (cu in per cylinder × rpm) ÷ 88,200, ID = √(1.273 A) (area rule)
  1. When the exhaust valve opens, a pressure pulse runs down the primary and returns from the collector as a low-pressure wave; length sets when it arrives.
  2. ED is the crank degrees from exhaust opening to TDC; the constant 850 folds in the wave speed of hot exhaust gas.
  3. The diameter rules size the pipe so gas speed stays in a useful range for the cylinder volume and rpm. The two rules give a range.

Worked example

Inputs

Exhaust opens (° BBDC)
70 °
Engine speed to tune for
6500 rpm
Displacement per cylinder
500 cc

Result

Primary length, valve to collector (approx.)29.7in
Primary inside diameter (Bell rule)1.64in
Primary inside diameter (area rule)1.69in
Exhaust degrees (180 + EVO)250°

Assumptions and limits

  • Labelled approximate: these are published rules of thumb, not a gas-dynamics model.
  • Length is measured from the valve, so subtract the exhaust port length to get tube length.
  • Tube sizes are inside diameters; add twice the wall thickness for the outside diameter.

Related terms

Frequently asked

How long should header primaries be?

A common rule gives length = 850 × (180 + exhaust opening ° BBDC) ÷ rpm − 3 inches, measured from the valve. Longer primaries tune lower in the rpm range. Treat it as a starting point, not an optimum.

How do I choose header primary diameter?

Rules of thumb size the pipe from cylinder volume and the rpm you want to tune for. Too large a primary slows the gas and weakens scavenging; too small restricts flow at high rpm. The two rules shown here give a sensible range.

Do I measure primary length from the valve or the flange?

From the valve. Subtract the exhaust port length in the head to get the tube length from the flange to the collector.

Answers draw on the sources below.

Sources

  1. Four-Stroke Performance Tuning (exhaust primary length and diameter rules) · A. Graham Bell, Haynes
  2. Header primary length · Stainless Headers · retrieved 2026-10-27
  3. Header primary sizing (area rule, 88,200 constant) · Stainless Headers · retrieved 2026-10-27
  4. Design and Simulation of Four-Stroke Engines (unsteady gas dynamics in intake and exhaust ducts) · G. P. Blair, SAE International, 1999

Spot an error? Tell us.