Clutch kick

clutch kickingkicking the clutchclutch dip

A clutch kick is a drifting technique in which the driver, holding steady throttle, quickly presses and releases the clutch. Engine speed flares while the clutch is open, and that energy hits the driven wheels when it re-engages, breaking rear tire grip to start or extend a slide.Medium645

How it works

Wikipedia lists the clutch kick as one of four traditional ways to start a drift, alongside power oversteer, weight transfer such as the Scandinavian flick, and the handbrake turn. It is used mostly in rear-wheel-drive cars with manual gearboxes.Medium6

The physics is stored rotational energy. With the clutch open, the engine and flywheel speed up freely. On re-engagement, their speed must drop to match the gearbox, and that energy reaches the tires as a brief torque spike above steady engine torque, enough to exceed rear tire grip.Medium42

Team O'Neil says the technique is most useful at low speed on high-grip surfaces, where throttle alone cannot break traction. Jalopnik adds that it suits cars without much power. On loose surfaces, throttle alone is usually enough.Medium45

Once the rear steps out, the driver holds the slide with countersteer and throttle. Wikipedia notes that a mechanical limited-slip differential is considered essential for drifting, because open differentials give weaker results in sustained slides.Medium6

Typical values

Driveline layoutRear-wheel drive with a manual gearboxTeam O'Neil says it also works in FWD and AWD carsSourced · medium64
Best conditionsLow speed on high-grip pavementSourced · medium4
DifferentialMechanical clutch-type limited slip preferredOpen and viscous units give weaker slidesSourced · medium6
Parts loaded by each kick

Clutch, throwout bearing, gearbox, driveshafts, axles, mounts and bushings

Sourced · medium46
ECU inputs involvedClutch switch, engine speed, wheel speed, traction control stateMatters when flat shift or launch logic watches the clutchSourced · medium37

How an ECU uses it

To the ECU, a clutch kick looks like a fast clutch press at high throttle.

If flat-shift logic is enabled, the clutch input can trigger a torque cut exactly when the driver wants a flare. GM's Camaro no-lift shift, for example, cuts torque with fuel and spark when the clutch is pressed above an enable rpm.3

Drift calibrations therefore often raise the flat-shift enable rpm or put it on a selector, so a kick produces a flare rather than a cut. A 2 step should disarm above a low road speed so it cannot hold the engine at launch rpm mid-corner.Low31

Traction and stability control see the wheelspin a kick creates and reduce torque, so drift use needs them off or in a sport mode. Logged rpm, driven and undriven wheel speed and clutch state show how large each flare and slip spike was.Medium72

How to test it

5 checks, in order.

  1. Practice only on a closed course or skid pad with run-off. Start at low speed in second gear on a surface you know well.Medium4
  2. Hold steady part throttle, press the clutch fully and quickly, let the revs rise a short way, then release it quickly. Jalopnik advises against letting revs climb too high before re-engaging.Medium45
  3. Catch the slide with countersteer and modulate the throttle to hold it. If the car snaps around, the flare was too large or the throttle too high after re-engagement.Low64
  4. Check the data afterward. Look at rpm flare, wheel speed spike and clutch switch timing in the log. A torque cut at the moment of the kick means flat-shift logic is triggering.Medium3
  5. Safety
    Inspect the clutch, engine and gearbox mounts, axles and driveshaft regularly if you clutch kick often. Team O'Neil warns that each dump shocks these parts and can break them.Medium4

Symptoms and causes

Engine stumbles or cuts when the clutch is kicked

Likely causes Flat-shift or launch logic triggering on the clutch input

Check Log clutch state and the torque-cut flag together; a cut on every press confirms it.

Medium3

Clutch slips after repeated kicks

Likely causes Glazed or worn friction surfaces from repeated shock and heat

Check Test for slip under load in a high gear, then inspect the disc and pressure plate.

Medium4

Clunk from the driveline on each kick

Likely causes Worn engine or gearbox mounts, differential bushings or driveshaft joints

Check Inspect for movement while a helper loads the driveline in gear.

Medium46

Car will not break traction

Likely causes Traction control active, open differential, or too small a flare

Check Confirm traction control state and compare left and right rear wheel speeds in the log.

Medium76

In tuning

On drift builds, decide how the clutch input is used.

Flat shift, 2 step and clutch kicks all share the same switch, so give each a clear enable condition such as rpm, road speed or a selector position.Low31

Throttle response after the kick matters more than peak torque. Drive-by-wire pedal maps and turbo spool both shape how the rear tires respond as the clutch bites, so tune transient response with the slide in mind.Low62

Common mistakes

Mistake Letting the revs flare too far before releasing the clutch.

Do instead Use small, quick flares; a bigger flare means a bigger shock through every driveline part.Medium54

Mistake Using clutch kicks as the default entry everywhere.

Do instead Use throttle, weight transfer or the handbrake when they work, and save kicks for low speed on grip.Medium46

Mistake Leaving traction control on.

Do instead Switch it off or use a sport mode, or it will cut torque the moment the rear slips.Medium7

Myths vs facts

Myth Clutch kicking only wears the clutch, which is a wear item anyway.

Fact Team O'Neil notes the shock also reaches the throwout bearing, gearbox, driveshafts and bushings, which can wear early or break.Medium4

Myth Clutch kicks only work in rear-wheel-drive cars.

Fact Team O'Neil says the technique also works in front- and all-wheel-drive cars. Competition drifting is almost entirely rear-drive, which is why it is linked with RWD.Medium46

Myth A clutch kick adds power.

Fact It adds no engine power. It releases rotational energy stored in the engine and flywheel as a short torque spike at the wheels.Medium42

Frequently asked

What is a clutch kick in drifting?

A clutch kick is a quick press and release of the clutch while holding throttle. The engine revs up with the clutch open, then sends a sudden torque surge to the rear wheels when it re-engages, breaking traction to start a drift. It works best at low speed on grippy pavement.Medium46

Does clutch kicking damage your car?

It adds wear. Each kick shock-loads the clutch, throwout bearing, gearbox, driveshafts, axles and bushings, which can wear early or break. Occasional kicks on a healthy car are tolerable, but regular drift use calls for frequent inspection and stronger parts.Medium45

Should you use a clutch kick or the handbrake to start a drift?

Use whichever suits the corner. A clutch kick suits low speed on high grip when throttle alone cannot break traction. The handbrake locks the rear wheels to swing the car, while power oversteer and weight transfer work at higher speed or on loose surfaces.Medium46

Can you clutch kick an automatic?

Not in the usual sense. A clutch kick needs a driver-operated clutch pedal to open and close the driveline on demand, so it belongs to manual-gearbox cars. Automatic drivers start drifts with throttle, weight transfer or the handbrake instead.Low46

Why does my car cut power when I clutch kick?

Usually flat-shift or no-lift-shift logic is reading the clutch switch and cutting torque, as GM's Camaro system does above its enable rpm. Traction control can also cut power once the rear slips. Logging the clutch state and torque-cut flag shows which one is acting.Medium37

Wiring, pinouts and parts

Used in these guides

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Launch control (automotive) · Wikipedia · reference · retrieved 2026-10-27
  2. Automotive Handbook, 10th edition (2018) · Robert Bosch GmbH / Wiley · book · retrieved 2026-10-27
  3. PIC6454A: Information on the No Lift Shift feature (Camaro 2016-2024) · General Motors (via NHTSA) · oem · retrieved 2026-10-27
  4. Clutch Kicking Explained · Team O'Neil Rally School · press · retrieved 2026-10-27
  5. Here's What A 'Clutch Kick' Is · Jalopnik · press · retrieved 2026-10-27
  6. Drifting (motorsport) · Wikipedia · reference · retrieved 2026-10-27
  7. Traction control system · Wikipedia · reference · retrieved 2026-10-27