Launch control

launch controltwo-step2-steplaunch rev limiterlaunch assist

Launch control is an engine and driveline strategy for repeatable standing starts. It holds engine speed at a set launch rpm while the car is stationary, then manages torque as the clutch engages so the tires stay near their best slip. On turbocharged engines it can also build boost before the start.Medium12

How it works

A launch needs the right engine speed and torque at the moment of drive engagement.

Too little and the engine bogs; too much and the tires spin. Launch control takes that balance away from the driver's feet.Medium21

With the system armed and the pedal pressed, the controller limits engine speed to a launch target using a secondary rev limiter, often called a two-step. Limiting may use spark cut, fuel cut, ignition retard or throttle control.Medium13

After release, the system manages torque to hold useful slip. PistonHeads reports that Chevrolet's Camaro ZL1 system adjusted engine torque 100 times per second. Some cars also use brakes or active differentials to shift torque between wheels.Medium2

Launch control differs from traction control. Traction control reacts to wheelspin by cutting torque; launch control sets the starting conditions and allows a planned amount of slip from the start.Medium21

In tuning

Launch rpm, torque ramp and slip targets depend on tire, surface, driveline and gearing.

Tune them with logs of engine speed, driven and undriven wheel speed and acceleration. Change one parameter at a time.Low14

Spark-cut and retard launch strategies used to build boost send fuel and heat into the exhaust and stress turbochargers and catalysts. Limit how long the launch limiter can stay active, and treat high-heat launch modes as competition-only.Medium35

Repeated launches load clutches, axles and differentials. PistonHeads notes that poor manual launches can wear clutches and damage drivetrains, which launch control aims to reduce; it does not remove the load.Medium2

Try it

rpm
:1
:1
in

Result

Road speed145.2 mph

Planning estimate from the formula below, not a measurement.

Open the full gear ratio speed calculator →

Myths vs facts

Myth Launch control is the same as traction control.

Fact Traction control reacts to slip after it starts. Launch control presets engine speed and manages torque from the moment of release.Medium2

Myth Higher launch rpm is always quicker.

Fact Excess rpm causes wheelspin and lost time once grip is exceeded. The best launch speed depends on traction.Medium21

Myth Launch control causes no extra wear.

Fact It makes launches consistent, but each hard launch still loads the clutch, axles and differential.Medium2

Frequently asked

How does launch control work?

The driver arms the system and holds the throttle down with the car stationary. The controller limits engine speed to a set launch rpm using a secondary rev limiter. When the clutch or brake is released, the system manages engine torque, and sometimes clutch pressure or brakes, to keep the tires near their best slip.Medium12

What is a two-step?

A two-step is a second rev limit, lower than the normal redline limit, that is active only while launching. It holds engine speed at the launch target while the car is stationary, then the normal limiter takes over once the car is moving. The name comes from having two separate rpm limits.Medium31

Is launch control bad for your car?

It is designed into many production cars and manages the launch more smoothly than most drivers. Each hard launch still stresses the clutch, gearbox, axles and tires, and spark-cut launch modes add heat to the exhaust. Occasional use within the maker's guidance is normal; frequent drag launches increase wear.Medium21

Does launch control build boost?

It can. Holding engine speed against a limiter lets a turbocharger start spooling before the car moves. Some systems add ignition retard or spark cut to send more energy to the turbine, which builds boost faster but raises exhaust temperature. Simple fuel-cut limiters build less boost.Medium15

Launch control vs traction control: what is the difference?

Launch control works before and during the first moments of a standing start, setting engine speed and planned torque. Traction control works any time the car is moving, cutting torque when it measures excess wheel slip. Many systems hand over from launch control to traction control as the car gains speed.Medium24

Wiring, pinouts and parts

Used in these guides

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Launch control (automotive) · Wikipedia · reference · retrieved 2026-10-25
  2. What is launch control? PH explains · PistonHeads · press · retrieved 2026-10-25
  3. Rev limiter · Wikipedia · reference · retrieved 2026-10-25
  4. Traction control system · Wikipedia · reference · retrieved 2026-10-25
  5. Antilag system · Wikipedia · reference · retrieved 2026-10-25