How it works
A hydrodynamic torque converter transmits power through fluid.
The stator lets it multiply torque while the turbine is much slower than the impeller. Once the turbine reaches roughly 90 percent of impeller speed, multiplication has essentially stopped and the converter behaves like a simple fluid coupling, still losing energy to slip.1
Many automotive converters include a lockup clutch that locks the turbine to the impeller so power passes mechanically. This improves cruising efficiency and reduces heat generated in the fluid. The transmission controller applies it through the torque converter clutch solenoid.14
Rather than simply on or off, many modern transmissions control a small amount of clutch slip to balance efficiency against driveline vibration. GM engineers describe model-based TCC slip control for this purpose, and a ZF paper notes slip-controlled converter clutches in every ZF transmission since 1994.25
In tuning
Lockup schedules matter for performance automatics.
Unlocking at launch keeps torque multiplication, while locking in higher gears at full throttle can reduce slip and fluid heat. The converter clutch must be rated for the engine's torque, because a slipping lockup clutch generates heat quickly and can glaze its friction surface.Medium12
Log engine speed against turbine speed to see actual converter slip. Rising slip with the clutch commanded on points to insufficient apply pressure or a worn clutch, and shows up first as rising transmission fluid temperature.Medium42
Try it
Result
Planning estimate from the formula below, not a measurement.
Myths vs facts
Myth Locking the converter always makes a car faster.
Fact Lockup removes fluid slip but also removes torque multiplication, which helps acceleration from low speed. Whether lockup helps depends on gear, speed and the converter's stall characteristics.1
Frequently asked
What does torque converter lockup do?
It engages a clutch inside the torque converter so the engine drives the transmission input mechanically instead of through fluid. That removes slip, improving fuel economy and reducing heat in the transmission fluid. It is typically applied at steady cruise and released when torque multiplication or extra damping is needed.12
Should the torque converter lock at wide-open throttle?
It depends on gear and speed. At launch and low speed, an open converter multiplies torque and helps acceleration. In higher gears at high speed, multiplication is negligible and lockup reduces slip and fluid heat. The lockup clutch must be rated for the engine's torque before locking at full load.Medium1
What is TCC slip control?
TCC slip control holds a small, controlled speed difference across the converter clutch instead of locking it fully. The transmission controller adjusts clutch pressure to target a slip value, which damps engine vibrations while recovering most of the efficiency of lockup. GM and ZF have both published work on slip-controlled converter clutches.25
Does lockup reduce transmission temperature?
Generally yes. A converter that is not locked turns slip into heat in the fluid, especially under load at highway speed. Locking or tightly controlling slip reduces that heat. A lockup clutch that slips under too much torque, however, generates heat of its own and can overheat the fluid.Medium12
Used in these guides
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
- Torque converter · Wikipedia · reference · retrieved 2026-10-27
- Model Based Torque Converter Clutch Slip Control (SAE 2011-01-0396) · SAE International · sae-paper · retrieved 2026-10-27
- Automatic transmission · Wikipedia · reference · retrieved 2026-10-27
- Transmission control unit · Wikipedia · reference · retrieved 2026-10-27
- Model-based design of slip-controlled converter clutches (Jauch, SAE 1999-01-1057) · SAE International · sae-paper · retrieved 2026-10-27

