Ethanol content calculator (flex sensor Hz to %)

On the GM/Continental flex fuel sensor, ethanol content (%) = frequency (Hz) − 50, so 50 Hz is E0 and 150 Hz is E100. The pulse width of each cycle encodes fuel temperature, from 1 ms at −40 °C to 5 ms at 125 °C.

Hz
%

Share of each period taken by the temperature pulse. If your logger reports the opposite edge, enter 100 minus its value.

Result

Ethanol content85.0 %
Fuel temperature51 °F
Temperature pulse width2.22 ms

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

Ethanol % = f(Hz) − 50;  pulse width (ms) = duty ÷ f × 1000;  T(°C) = −40 + (pulse width − 1) × 41.25
  1. The sensor outputs a square wave whose frequency rises linearly with ethanol content: 50 Hz at 0% to 150 Hz at 100%.
  2. Each period also carries a pulse whose width rises linearly with fuel temperature: 1 ms at −40 °C to 5 ms at 125 °C (41.25 °C per ms).
  3. Pulse width is the duty cycle share of one period; one period is 1 ÷ frequency.

Worked example

Inputs

Sensor frequency
135 Hz
Temperature pulse duty cycle
30 %

Result

Ethanol content85.0%
Fuel temperature51°F
Temperature pulse width2.22ms

Assumptions and limits

  • GM/Continental-type sensor (GM 13577429 family) with an open-collector output and a pull-up to 5 V in the ECU. Other sensors may use different scaling.
  • Published figures come from distributor product data for the GM part; the Continental data sheet is not publicly hosted, so check against your sensor's documentation.
  • The sensor reads ethanol plus water and other alcohols together.

Related terms

Frequently asked

What frequency does a flex fuel sensor output for E85?

On the GM/Continental sensor, ethanol percent equals frequency minus 50, so nominal E85 reads about 135 Hz. Pump E85 is often 51-83% ethanol, so expect anywhere from about 101 to 133 Hz at the pump.

How does the flex fuel sensor report fuel temperature?

Through the width of each pulse rather than the frequency. 1 ms means −40 °C and 5 ms means 125 °C, linear in between (41.25 °C per ms). Pulse width is duty cycle divided by frequency.

What does a flex fuel sensor reading above 150 Hz mean?

The sensor is outside its 50-150 Hz operating range. Treat it as a fault: wiring, a failed sensor or contaminated fuel such as water in the tank. Most ECUs fall back to a default ethanol value when the input is out of range.

Do I need a pull-up resistor for a flex fuel sensor?

Usually yes. The output is open-collector and pulls the signal to ground, so the input needs a pull-up to 5 V. Many ECUs have one built into their frequency inputs; check your ECU's input specification.

Answers draw on the sources below.

Sources

  1. GM / Continental ethanol content sensor 13577429: output specification (frequency = ethanol %, pulse width = fuel temperature) · Racetronix (GM part distributor) product data
  2. How to find out what percentage of ethanol is in your fuel · High Performance Academy
  3. ASTM D5798: Standard Specification for Ethanol Fuel Blends for Flexible-Fuel Automotive Spark-Ignition Engines · ASTM International

Spot an error? Tell us.