Fuel injector calculator

Injector size per injector = horsepower × BSFC ÷ (number of injectors × maximum duty cycle). Enter your power target and fuel to get the static flow each injector needs, in lb/hr and cc/min.

hp
:1

Typical: gasoline NA 0.45-0.50, gasoline boosted 0.55-0.65, E85 NA 0.65-0.75, E85 boosted 0.80-0.90 lb/hp-hr.

%

Size for 80-85% so the injector still has control margin at peak power.

Result

Flow per injector75.0 lb/hr
Total fuel flow240 lb/hr

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

lb/hr per injector = (hp × BSFC) ÷ (injectors × duty); cc/min ≈ lb/hr × 10.5
  1. Fuel mass flow at peak power is horsepower times brake specific fuel consumption (BSFC).
  2. Divide by the number of injectors, then by the maximum duty cycle you want to run.
  3. cc/min uses the industry conversion of 10.5, which assumes a test fluid of about 0.72 g/cc.

Worked example

Inputs

Target crank horsepower
400 hp
BSFC
0.6 :1
Number of injectors
4
Maximum duty cycle
80 %

Result

Flow per injector75.0lb/hr
Total fuel flow240lb/hr

Assumptions and limits

  • Rated flow is at the injector's rated differential pressure; flow changes with the square root of pressure.
  • Crank horsepower; wheel figures need drivetrain loss added first.
  • BSFC is an estimate; a lean or rich target, efficiency and fuel change it.

Related terms

Frequently asked

What size injectors do I need for 400 hp?

On gasoline with a turbo (BSFC about 0.60), 400 crank hp needs about 240 lb/hr of fuel. Across 4 injectors at 80% duty that is 75 lb/hr (about 790 cc/min) each; across 8 injectors, about 37.5 lb/hr (about 395 cc/min). On E85, plan for roughly 40-50% more fuel.

How do I convert lb/hr to cc/min?

Multiply lb/hr by about 10.5 to get cc/min, and divide cc/min by 10.5 to get lb/hr. The 10.5 factor assumes a fuel density near 0.72 g/cc, which is close to the test fluids used to rate injectors. Real pump gasoline is slightly denser.

Why size injectors for 80% duty cycle?

Near 100% duty, the injector is almost always open, so the ECU can no longer add fuel or trim it accurately. Sizing for 80-85% at peak power leaves headroom for hot fuel, low voltage, richer targets and future power.

How much bigger do injectors need to be for E85?

E85 needs roughly 40-50% more fuel by mass than gasoline for the same power, because its stoichiometric ratio is about 9.8:1 versus 14.7:1 and it carries less energy per kilogram. Use an E85 BSFC preset, which already includes that increase.

Answers draw on the sources below.

Sources

  1. Automotive Handbook · Robert Bosch GmbH
  2. Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018

Spot an error? Tell us.