Tire growth calculator: gear speed at rpm with tire growth
Tires, especially drag radials and bias slicks, grow at speed, which raises road speed at a given rpm: speed = rpm × grown diameter ÷ (gear × final drive × 336.13). Enter tire size, growth and slip to compare static and grown speed.
Result
Planning estimate from the formula below, not a measurement.
How it works
The formula, the method step by step, then a worked example.
D_grown = D × (1 + growth); mph = rpm × D_grown ÷ (gear × final drive × 336.13) × (1 − slip)
- Each revolution of the tire moves the car one circumference, π × diameter.
- Engine rpm divided by the overall ratio gives wheel rpm; 336.13 converts inches per minute to mph with π included.
- Growth at speed increases the effective diameter, which works like a taller final drive.
- Converter or clutch slip reduces wheel speed below what the engine rpm implies.
Worked example
Inputs
- Tire diameter (static)
- 28 in
- Growth at speed
- 3 %
- Engine speed
- 6500 rpm
- Gear ratio
- 1 :1
- Final drive ratio
- 3.73 :1
- Converter or clutch slip
- 0 %
Result
Assumptions and limits
- Growth is entered as a single value at the speed of interest; real growth rises with speed and pressure.
- Static (unloaded) diameter; the loaded rolling radius is slightly smaller.
- Planning estimate; the tire's speed and load rating always apply.
Related terms
Frequently asked
How much do drag radials grow?
It depends on the tire, pressure and speed. Street radials grow very little; drag radials and bias slicks can grow a few percent at the top of a pass. The reliable way to find it is to log engine rpm against GPS speed.
How does tire growth affect gearing?
Growth makes the tire effectively taller, like a lower numerical final drive. A 3% growth on a 3.73 final drive behaves like about 3.62, so the car reaches the end of the track at lower rpm than the static size suggests.
Why is my trap rpm lower than the calculator predicts?
Tire growth raises speed per rpm, while converter slip lowers it. Enter both to match logged data, then use the result to choose the gear ratio that crosses the finish near peak power.
Answers draw on the sources below.
Sources
- Automotive Handbook · Robert Bosch GmbH
- Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
Spot an error? Tell us.

