Wasted spark ignition

wasted sparkdistributorless ignitionDISEDISpaired coil ignition

Wasted spark ignition is a distributorless system in which one coil fires two spark plugs at once, on cylinders whose pistons reach top dead center together. One cylinder is on compression and gets the useful spark. The other is on its exhaust stroke, where the spark does nothing.12

How it works

On a four-stroke engine, pairs of cylinders reach top dead center at the same time, one at the end of compression and one at the end of exhaust. A wasted-spark coil has both ends of its secondary winding connected to plugs, one in each cylinder of a pair, so both fire every revolution.Medium1

The exhaust-stroke cylinder holds low-pressure gas, so its plug needs little voltage to fire. Almost all of the coil's energy goes to the compression-stroke plug, which needs high voltage to break down the dense charge.12

Current flows in opposite directions through the two plugs, so one fires with reversed polarity. That plug can wear differently, which is why some wasted-spark engines specify platinum or iridium plugs on both electrodes.Medium1

Because every coil fires once per revolution, wasted spark needs only the crank position, not cam phase. That made it popular for early distributorless systems and is still used where a cam signal is unavailable.12

In tuning

Wasted spark works well up to high rpm, but each coil gets half the charge time of coil-on-plug because it fires every revolution.

Dwell must be set for that, and the coil must handle the higher duty.Medium12

Per-cylinder timing trims are limited. Both cylinders of a pair share the same spark event, so timing can be trimmed per pair, not per cylinder, unless the engine is converted to sequential coils with a cam signal.Medium2

Myths vs facts

Myth The wasted spark wastes half the ignition energy.

Fact The exhaust-stroke plug fires at low voltage in low-pressure gas, so it uses only a small share of the energy. The useful spark gets most of it.Medium1

Myth Wasted spark cannot work at high rpm.

Fact Many high-revving engines have used it. Its limit is dwell time per revolution, which the coil and calibration must account for.Medium12

Frequently asked

How does wasted spark work?

Each coil connects to two spark plugs on cylinders that reach top dead center together. When the coil fires, both plugs spark at once. One cylinder is at the end of compression and ignites; the other is at the end of exhaust and the spark is wasted. On the next revolution their roles swap.Medium1

Is wasted spark as good as coil-on-plug?

For most uses it ignites the mixture just as well. Coil-on-plug gives each coil twice the charge time, removes plug leads in most designs and allows per-cylinder timing and misfire detection. Wasted spark is simpler and needs no cam sensor. Which is better depends on rpm, packaging and controller features.Medium132

Does wasted spark need a cam sensor?

No. Each coil fires every crank revolution, so the controller only needs crank position to know when a pair of cylinders is at top dead center. That is one reason early distributorless systems used wasted spark. Sequential fuel injection still needs a cam signal even if ignition does not.12

Why is it called wasted spark?

Because one of the two sparks from each coil happens in a cylinder on its exhaust stroke, where there is no fresh mixture to ignite. That spark does no work, so it is wasted. It costs little energy because the low-pressure exhaust gas needs only a small voltage to break down.Medium1

Used in these guides

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

  1. Wasted spark · Wikipedia · reference · retrieved 2026-10-25
  2. Automotive Handbook, 10th edition · Robert Bosch GmbH · book · retrieved 2026-10-25
  3. Ignition system · Wikipedia · reference · retrieved 2026-10-25