Toyota · CT family · Gasoline

Toyota CT26

CT26CT26 twin entry17201-7401017201-74060Toyota in-house turboInternal wastegateWater-cooledSingle- and twin-entry versionsCracks at the wastegate port

The Toyota CT26 is the factory turbo on the 7M-GTE Supra and Soarer and on second-generation-and-earlier 3S-GTE Celica GT-Four and MR2 Turbo models. Toyota fitted a single-entry CT26 to the 1986-1989 ST165 and a twin-entry version with two wastegate ports to the 1990-1993 ST185 and SW20 MR2. Its known weak spot is cracking around the wastegate port.Medium1212

CompressorjournalwaterwastegateTurbine
Illustration of the layout, not the part.

Cars and engines

7 factory applications

VehicleEngineYearsPart number
Toyota Celica GT-Four / All-Trac (ST165)3S-GTE (gen 1)1986-198917201-74010Single-entry turbine housing.Medium134
Toyota Celica GT-Four / All-Trac (ST185), incl. GT-Four RC3S-GTE (gen 2)1990-199317201-74060Twin-entry turbine housing with dual wastegate ports.Medium15
Toyota MR2 Turbo (SW20)3S-GTE (gen 2)1990-1993—Same twin-entry CT26 generation as the ST185.Medium1
Toyota Supra Turbo (MA70)7M-GTE1987-199217201-42020 (also cross-referenced as 17201-42010)Medium26
Toyota Soarer (MZ20/MZ21)7M-GTE1986-199117201-42020Medium27
Toyota Supra Turbo A (Japan homologation special)7M-GTEULimited run (year not stated in source)—Wikipedia describes a modified high-flow CT26 for this model.Medium2
Toyota Land Cruiser (J60)12H-T (4.0 L diesel)1980-1989—Low8

Specifications

Wheel sizes vary by source and revision; differences are flagged.

Housings and hardware

SpecValueSource
Turbine housing (3S-GTE gen 1)Single entryMedium1
Turbine housing (3S-GTE gen 2)Twin entry with dual wastegate portsMedium1
WastegateInternal flapper, pneumatic actuatorMedium121
CoolingOil and water cooledLow6
Turbine inlet4-bolt flangeFrom a 7M-GTE replacement listing.Low6
BearingJournal bearingCommonly stated; no Toyota document found.UnverifiedLow7

Wheels

SpecValueSource
Turbine wheel (7M-GTE)51.9 mm / 67.9 mmGiven as the stock size in one cartridge seller's listing; no Toyota figure found. Compressor wheel sizes were not found in a reliable source.UnverifiedLow9

Factory boost (3S-GTE, per Wikipedia)

SpecValueSource
Gen 1 ST1658-9 psi (0.55-0.62 bar); fuel cut 12 psi (0.83 bar)Medium1
Gen 2 ST185 / MR210-11 psi (0.69-0.76 bar); 16 psi (1.1 bar) on GT-Four RCMedium1
7M-GTENot confirmedWikipedia's 5 psi figure is not supported by a cited factory document; check the service manual.UnverifiedLow2

What the CT26 is

The CT26 turbo is a Toyota-designed unit used through the late 1980s and early 1990s.

It boosted the 3.0 L inline-six 7M-GTE and the 2.0 L 3S-GTE four-cylinder in its first two generations.Medium21

Toyota rated the 7M-GTE at 232 hp (173 kW) and the Japanese ST185 3S-GTE at 225 PS (165 kW). Both figures come from Wikipedia's engine pages and vary by market.Medium21

Single-entry vs twin-entry CT26

The ST165 Celica used a single-entry CT26.

For the ST185 and the SW20 MR2, Toyota switched to a twin-entry turbine housing with two wastegate ports.Medium1

The two do not interchange as complete units without matching manifolds. Part numbers help: 17201-74010 is the ST165 unit and 17201-74060 is listed for the ST185.Medium453

In 1994 the gen 3 3S-GTE replaced the CT26 with the smaller CT20b, still twin-entry.Medium1

How to identify a CT26

The Toyota part number on the housing tag or in the parts catalog is the reliable check.

17201-42020 is the 7M-GTE unit; 17201-74010 and 17201-74060 are 3S-GTE units.Medium645

Look at the turbine inlet. A twin-entry housing has a divider down the middle and two wastegate ports under the flapper.Medium1

The wastegate-port crack

Owners report that most CT26 turbine housings sent for upgrades are cracked around the wastegate port.

Cracks often show only once the flapper is opened.Low1213

A crack that reaches the flapper seat can stop the flapper sealing and cause a boost leak or erratic boost. Owners replace the housing at that point; aftermarket 8 cm² CT26 housings exist.Low1311

Common problems

What fails, why, and the usual fix.

  1. 1Cracks around the wastegate port

    Usual cause

    Heat cycling of the cast-iron turbine housing; owners report it on most used CT26s.

    Fix

    Inspect with the flapper open during any rebuild; replace the housing when a crack reaches the flapper seat.Low1213

  2. 2Erratic or low boost with a worn turbo

    Usual cause

    Flapper not sealing on a cracked seat, or worn wastegate linkage.

    Fix

    Check the flapper seat and actuator before chasing other boost leaks.Low13

  3. 3Oil smoke and shaft play

    Usual cause

    Worn bearings and seals on high-mileage units.

    Fix

    Rebuild the center cartridge or fit a replacement CHRA.Low9

Upgrade paths

The routes owners take from the factory unit.

Hybrid

CT26 with GT3071R cartridge (7M-GTE)

Kinugawa sells a GT3071R center section for the 7M-GTE CT26 housings. Its listing says the stock compressor housing must be machined to take the larger wheel.Low9

Bolt-on

TD05H-16K on a CT26 flange (3S-GTE)

Kinugawa sells TD05H-based turbos built to bolt to the ST165 and MR2 3S-GTE in place of the CT26.Low10

Big single

Larger single on a new manifold

Larger builds move to a new manifold and a modern frame. Compare compressor maps such as the G30-770 against the engine's airflow target.Low9

Garrett G30-770 compressor map →

Frequently asked

What cars have a CT26 turbo?

The 1987-1992 MA70 Supra Turbo and 1986-1991 Soarer with the 7M-GTE, the 1986-1989 ST165 Celica GT-Four, and the 1990-1993 ST185 Celica GT-Four and SW20 MR2 Turbo with the 3S-GTE. Some 1980s Land Cruiser diesels also used a CT26.Medium218

Is the CT26 twin scroll?

Some are. Wikipedia records a single-entry CT26 on the first-generation 3S-GTE (ST165) and a twin-entry housing with dual wastegate ports on the second generation (ST185 and SW20 MR2). Check for a divider in the turbine inlet to confirm which one you have.Medium1

Why do CT26 turbine housings crack?

The cast-iron housing heat-cycles hardest around the wastegate port, and owners report that most used CT26s show cracks there. Small surface cracks are common; replace the housing when a crack reaches the flapper seat or the flapper stops sealing.Low1213

What is the difference between the ST165 and ST185 CT26?

The ST165 (1986-1989) unit is single-entry, part 17201-74010. The ST185 (1990-1993) unit is twin-entry with two wastegate ports, listed as 17201-74060. Toyota raised factory boost from 8-9 psi to 10-11 psi with the change.Medium145

How much boost does a stock CT26 run?

Wikipedia gives 8-9 psi (0.55-0.62 bar) for the ST165, 10-11 psi (0.69-0.76 bar) for the ST185 and MR2, and 16 psi (1.1 bar) for the GT-Four RC. Factory 7M-GTE boost should be checked in the service manual.Medium12

Related

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

13 sources
  1. Toyota S engine (3S-GTE generations) · Wikipedia · reference · retrieved 2026-11-04
  2. Toyota M engine (7M-GTE) · Wikipedia · reference · retrieved 2026-11-04
  3. Toyota 17201-74010 turbocharger sub-assy · Nengun (Toyota OEM parts) · oem · retrieved 2026-11-04
  4. 17201-74010 CT26 turbocharger replacement for Toyota Celica 3S-GTE · LeadTurbo · vendor-doc · retrieved 2026-11-04
  5. 17201-74060 CT26 turbocharger replacement for Toyota Celica GT-Four ST185 3S-GTE · LeadTurbo · vendor-doc · retrieved 2026-11-04
  6. CT26 turbocharger 17201-42020 for Toyota Supra 7M-GTE · FridayParts · vendor-doc · retrieved 2026-11-04
  7. Toyota Soarer 3.0 L 7M-GTE CT26 turbo 17201-42020 · Maxpeedingrods · vendor-doc · retrieved 2026-11-04
  8. Toyota Land Cruiser J60 4.0 L 12H-T 1980-1989 CT26 turbocharger · Maxpeedingrods · vendor-doc · retrieved 2026-11-04
  9. CT26-GT3071R for Toyota Supra 7M-GTE MK3 MA70 (bolt-on) · Kinugawa Turbo Systems · vendor-doc · retrieved 2026-11-04
  10. TD05H-16K 7cm for Toyota Celica ST165, MR2 3S-GTE · Kinugawa Turbo Systems · vendor-doc · retrieved 2026-11-04
  11. TRITDT 8cm turbine housing for Toyota CT26 (1HD-T, 3S-GTE) · eBay listing (TRITDT) · vendor-doc · retrieved 2026-11-04
  12. CT26 wastegate cracks · Supramania · community · retrieved 2026-11-04
  13. Cracked turbo housing: how much is OK? · Supramania · community · retrieved 2026-11-04

Brand and model names identify the turbo and the vehicles it was fitted to; GAINS is not affiliated with their makers.