BMEP calculator: brake mean effective pressure from torque
BMEP = 4π × torque ÷ displacement for a four-stroke engine (150.8 × lb-ft ÷ cubic inches, in psi). It compares how hard engines of any size work. Enter torque and displacement to get BMEP in psi, bar or kPa and torque per litre.
Result
Planning estimate from the formula below, not a measurement.
How it works
The formula, the method step by step, then a worked example.
BMEP = 2π n_R T ÷ V_d (n_R = 2 four-stroke, 1 two-stroke); four-stroke: BMEP(psi) = 150.8 × T(lb-ft) ÷ V_d(cu in); BMEP(bar) = 12.566 × T(Nm) ÷ V_d(cc)
- Work per cycle is 2π × torque × the revolutions per cycle (two for a four-stroke).
- Dividing that work by displacement gives a pressure: the average cylinder pressure that would produce the measured torque.
- Because it removes engine size, BMEP compares engines of different displacement on the same footing.
Worked example
Inputs
- Torque
- 147.51 lb-ft
- Displacement
- 122.05 cu in
- Cycle
- 4
Result
Assumptions and limits
- Brake (crank) torque; wheel torque would understate BMEP.
- Heywood gives typical maximum BMEP of about 850-1,050 kPa for naturally aspirated spark-ignition engines and 1,250-1,700 kPa turbocharged; use it as context, not a target.
- Default inputs are a hand-checked example: 200 Nm from 2.0 litres = 12.57 bar.
Related terms
Frequently asked
What is BMEP?
Brake mean effective pressure is the average cylinder pressure that would produce the engine's measured torque. It equals 4π × torque ÷ displacement on a four-stroke, so it compares how hard engines of different sizes work.
How do you calculate BMEP from torque?
For a four-stroke, BMEP (psi) = 150.8 × torque (lb-ft) ÷ displacement (cubic inches), or BMEP (bar) = 12.566 × torque (Nm) ÷ displacement (cc). 200 Nm from a 2.0 litre engine is about 12.6 bar.
What is a typical BMEP?
Heywood lists maximum BMEP of about 850-1,050 kPa (8.5-10.5 bar) for naturally aspirated spark-ignition engines and 1,250-1,700 kPa turbocharged. Higher values mean more cylinder pressure and more load on the engine.
Answers draw on the sources below.
Sources
- Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
- 2.61 Internal Combustion Engines (lecture notes: engine geometry and performance parameters) · MIT OpenCourseWare · retrieved 2026-10-27
Spot an error? Tell us.

