Boost to horsepower calculator

Estimate the airflow and boost pressure an engine needs for a target horsepower, using the airflow-and-manifold-pressure method published by turbo makers. Results feed straight into compressor-map matching.

hp
cu in
rpm
%
:1
:1

Typical: gasoline NA 0.45-0.50, gasoline boosted 0.55-0.65, E85 NA 0.65-0.75, E85 boosted 0.80-0.90 lb/hp-hr.

°F
ft
psi
psi

Result

Airflow required44.0 lb/min
Boost (gauge)25.1 psi
Manifold absolute pressure39.8 psi
Compressor pressure ratio3.05 :1

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

Wa = hp × AFR × BSFC ÷ 60;  MAP = Wa × 639.6 × (460 + T) ÷ (VE × rpm/2 × CID);  PR = (MAP + ΔP_loss) ÷ (P_amb − ΔP_inlet)
  1. Airflow needed is horsepower × AFR × BSFC ÷ 60 (lb/min).
  2. The manifold pressure that pushes that much air through the engine follows from the ideal gas law, the engine's displacement, rpm and VE.
  3. Add the pressure lost through the intercooler and piping, and divide by the pressure at the compressor inlet to get the pressure ratio for the compressor map.

Worked example

Inputs

Target crank horsepower
400 hp
Displacement
122 cu in
Rpm at peak power
7200 rpm
Volumetric efficiency
95 %
Air-fuel ratio
12 :1
BSFC
0.55 :1
Manifold air temperature
130 °F
Altitude
0 ft
Intercooler and piping pressure loss
2 psi
Intake (pre-turbo) pressure loss
1 psi

Result

Airflow required44.0lb/min
Boost (gauge)25.1psi
Manifold absolute pressure39.8psi
Compressor pressure ratio3.05:1

Assumptions and limits

  • VE, BSFC and losses are estimates; real engines vary with cams, exhaust back-pressure and fuel.
  • Planning estimate, not a dyno result.

Related terms

Frequently asked

How much boost do I need for 400 hp?

It depends on displacement, rpm, VE and charge temperature. Using a turbo maker's worked example, a 2.0 L engine at 7,200 rpm needs about 25 psi of boost for 400 crank hp; a 5.3 L engine needs far less. Enter your engine to estimate it.

How much airflow makes a horsepower?

With gasoline at 12:1 AFR and a BSFC of 0.55, each crank horsepower needs about 0.11 lb/min of air, so 10 lb/min supports roughly 90-100 hp. Richer mixtures, ethanol and efficiency change the ratio.

Is this calculator accurate for my turbo?

It estimates the airflow and pressure ratio the engine needs. Plot those points on your compressor map to check efficiency and surge margin. Real results depend on cams, exhaust back-pressure, fuel and tuning.

Answers draw on the sources below.

Sources

  1. Turbo Tech 103: Expert compressor matching · Garrett Motion
  2. Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
  3. U.S. Standard Atmosphere, 1976 · NOAA / NASA / USAF

Spot an error? Tell us.