cc to hp calculator (rough estimate from displacement)

Displacement alone does not fix horsepower, but it bounds it: power = BMEP × displacement × rpm ÷ 2 (four-stroke). Using published typical BMEP ranges, enter cc, peak-power rpm and aspiration for a rough estimated range, not a rating.

cc
rpm

Result

Estimated power, low end105 hp
Estimated power, high end137 hp
Specific output, low (hp per litre)52
Specific output, high (hp per litre)69
BMEP range used (kPa)723 to 945 kPa

Rough estimate, not a rating: real engines fall outside this range with different rpm, boost, fuel and design. Use a dyno to measure power.

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

P (kW) = BMEP (kPa) × V_d (L) × rpm ÷ 120,000;  BMEP at rated power ≈ 0.85-0.90 × typical maximum (NA 850-1,050 kPa; boosted 1,250-1,700 kPa)
  1. Power equals mean effective pressure × displacement × power strokes per minute; a four-stroke fires each cylinder every second revolution.
  2. Heywood gives typical maximum BMEP ranges for naturally aspirated and boosted spark-ignition engines; at rated power BMEP is typically 10-15% lower.
  3. Multiply that range by displacement and the rpm of peak power to get a range of plausible power.

Worked example

Inputs

Displacement
2000 cc
Engine speed at peak power
6500 rpm
Aspiration
0

Result

Estimated power, low end105hp
Estimated power, high end137hp
Specific output, low (hp per litre)52
Specific output, high (hp per litre)69
BMEP range used (kPa)723

Assumptions and limits

  • Labelled rough estimate from typical published ranges; it says nothing about a specific engine.
  • Four-stroke spark-ignition engines; diesels, two-strokes, rotaries and race engines are outside the ranges used.
  • Crank power. The rpm you enter matters as much as displacement.

Related terms

Frequently asked

How many hp per cc?

There is no fixed figure. Power depends on rpm, cylinder pressure (BMEP), boost and fuel as much as on size. With the typical published BMEP ranges used here, a naturally aspirated engine peaking at 6,500 rpm works out to roughly 52-69 hp per litre. It is a rough range, not a rating.

How much horsepower is 2000cc?

It depends mostly on rpm and aspiration. Using typical published BMEP ranges, a naturally aspirated 2.0 litre engine peaking at 6,500 rpm falls roughly between 105 and 137 hp. Real engines sit outside that range for many reasons.

Why is cc to hp only an estimate?

Displacement sets how much air each cycle can hold, but not how well the engine fills it, how fast it turns, or whether it is boosted. Treat the range as a sanity check, and measure power on a dyno.

Answers draw on the sources below.

Sources

  1. Internal Combustion Engine Fundamentals (2nd ed.), ch. 2: engine performance parameters (bmep, typical maximum and rated-power values) · J. B. Heywood, McGraw-Hill, 2018
  2. 2.61 Internal Combustion Engines (lecture notes: engine geometry and performance parameters) · MIT OpenCourseWare · retrieved 2026-10-27

Spot an error? Tell us.