CFM to horsepower calculator: airflow for a power target
Airflow needed = horsepower × BSFC × air-fuel ratio ÷ 60, in lb/min, and about 1.4 CFM per horsepower at standard air on gasoline. Enter a power target, or an airflow, to convert between power and airflow.
Result
Estimate: BSFC and air-fuel ratio vary with the engine and tune. For airflow from displacement and rpm, use the engine airflow (CFM) calculator.
Planning estimate from the formula below, not a measurement.
How it works
The formula, the method step by step, then a worked example.
fuel (lb/hr) = hp × BSFC; air (lb/min) = fuel × AFR ÷ 60; CFM = lb/min ÷ 0.0765 lb/ft³ (standard air)
- Power needs fuel: brake specific fuel consumption (BSFC) is fuel mass per horsepower-hour.
- Every pound of fuel needs AFR pounds of air.
- Divide by standard air density (0.0765 lb/ft³ at 59 °F and 14.7 psia) to express mass flow as CFM.
Worked example
Inputs
- Power target (crank)
- 400 hp
- BSFC
- 0.5 :1
- Air-fuel ratio at full load
- 12.5 :1
- Airflow to check (optional, CFM at standard air)
- 0
Result
Assumptions and limits
- Labelled estimate: BSFC and AFR are typical full-load values, not measured.
- CFM at standard air; turbo and compressor maps use lb/min, which does not depend on conditions.
- Crank power; add drivetrain loss for wheel figures.
Related terms
Frequently asked
How much CFM do I need per horsepower?
On gasoline at full load (BSFC about 0.50 and an air-fuel ratio of about 12.5), each horsepower needs about 0.104 lb/min of air, which is about 1.36 CFM at standard air. Both figures are estimates that change with the engine and tune.
What is the difference between CFM and lb/min?
CFM is volume flow and depends on air density; lb/min is mass flow and does not. Turbo compressor maps use lb/min. At standard air (59 °F, 14.7 psia), 1 lb/min is about 13.1 CFM.
How do I work out CFM from engine size?
Use the engine airflow calculator: CFM = cubic inches × rpm × volumetric efficiency ÷ 3456 for a four-stroke. This page works the other way, from a power target to the airflow it needs.
Answers draw on the sources below.
Sources
- Internal Combustion Engine Fundamentals (2nd ed.), ch. 2: engine performance parameters (bmep, typical maximum and rated-power values) · J. B. Heywood, McGraw-Hill, 2018
- U.S. Standard Atmosphere, 1976 (sea-level density 1.225 kg/m³ at 15 °C) · NOAA / NASA / USAF · retrieved 2026-10-27
- Automotive Handbook · Robert Bosch GmbH
Spot an error? Tell us.

