Fuel conversion calculator: injector scaling for E85 and methanol

At the same lambda, fuel mass scales with the stoichiometric ratio: E85 needs about 1.5 times gasoline's mass and methanol about 2.3 times. Pick the old and new fuel to get the mass, volume and pulse-width multipliers and the equivalent injector size.

lb/hr

The injector that suits the current fuel at your current duty cycle.

Result

Pulse width multiplier (same injector)1.461 :1
Equivalent injector size (same duty)61.4 lb/hr
Fuel mass multiplier1.500 :1
Fuel volume multiplier1.424 :1

Check that the larger injectors still meter well at idle, and that the pump and lines carry the extra volume.

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

mass × = AFR_st(old) ÷ AFR_st(new);  volume × = mass × × ρ_old ÷ ρ_new;  pulse width × = mass × ÷ √(ρ_new ÷ ρ_old)
  1. At the same lambda, the fuel mass needed per unit of air is inversely proportional to the fuel's stoichiometric ratio.
  2. Convert to volume with the two densities to size the pump and lines.
  3. An injector passes fuel mass in proportion to the square root of density at a fixed pressure, so a denser fuel needs slightly less extra pulse width than its extra mass.

Worked example

Inputs

Current fuel
0
New fuel
2
Current injector size
42 lb/hr

Result

Pulse width multiplier (same injector)1.461:1
Equivalent injector size (same duty)61.4lb/hr
Fuel mass multiplier1.500:1
Fuel volume multiplier1.424:1

Assumptions and limits

  • Stoichiometric ratios and densities are typical table values (gasoline 14.7 and 0.745 g/cc, E85 9.8 and 0.785, methanol 6.4 and 0.792); real pump E85 often contains less ethanol than its label.
  • Same lambda target and same fuel pressure. Alcohols are usually run at a different lambda at full load; set the target separately.
  • Ignores viscosity and cold-start effects; alcohol fuels need much more cranking and warm-up enrichment.

Related terms

Frequently asked

How much more fuel does E85 need than gasoline?

At the same lambda, about 1.5 times the mass (14.7 ÷ 9.8). By volume about 1.42 times, because E85 is denser. A given injector delivers about 2.6% more mass of E85 per millisecond, so the pulse width rises by about 46%.

How much bigger do injectors need to be for methanol?

At the same lambda, methanol needs about 2.3 times the fuel mass of gasoline (14.7 ÷ 6.4). Allowing for its density, injectors need roughly 2.2 times the flow at the same duty cycle, before any richer target.

Does this include running richer on alcohol?

No. The multipliers are at the same lambda. If you also run a richer target, divide by the new lambda target as well, and check pump and line capacity for the extra volume.

Answers draw on the sources below.

Sources

  1. Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
  2. Automotive Handbook · Robert Bosch GmbH

Spot an error? Tell us.