Cars and engines
4 factory applications
| Vehicle | Engine | Years | Part number |
|---|---|---|---|
| Nissan Silvia K's (S14) / 200SX (S14, S14a) | SR20DET | 1994-1998 | 14411-69F00 (listed for S14/S15 non-Spec R)Owners report a single-ball-bearing T28 on the S14.Medium12 |
| Nissan Silvia Spec-R (S15, JDM) | SR20DET | 1999-2002 | 14411-91F00 (listed by retailers)Dual-ball-bearing GT2560R with a divider cast in the turbine housing. One owner says some Spec Rs had non-ball-bearing turbos.Medium123 |
| Nissan 200SX Spec-R / Spec-S (S15, AU and NZ) | SR20DET | 1999-2002 | —Low14 |
| Nismo 270R (S14 based) | SR20DET | 1994 | —SR20DET application listed by Wikipedia; turbo specification not confirmed.Low1 |
Specifications
Wheel sizes vary by source and revision; differences are flagged.
Compressor
Turbine and hardware
| Spec | Value | Source |
|---|---|---|
| Turbine housing A/R (S15 GT2560R) | 0.64 | Low6 |
| Turbine housing | Divider cast in on S15 Spec R; open on S14 / non-Spec R | Low2 |
| Bearing | Single ball bearing (S14); dual ball bearing GT2560R (S15 Spec R)Owner-reported; one post says some S15 Spec Rs had non-ball-bearing turbos. | Low2 |
| Wastegate | Internal, pneumatic actuator | Low7 |
| Oil drain gasket | 15196-69F00, roller (ball) bearing turbos only | Medium8 |
| Factory boost | Not confirmed in the sources foundCheck the service manual for your market. | UnverifiedLow1 |
What the SR20DET T28 is
The SR20DET T28 is a Garrett T28-series turbo on the later rear-drive SR20DET, the 2.0 L four in the S14 and S15 Silvia and 200SX.
Wikipedia lists the SR20DET's turbo as a Garrett T25G or T28 depending on version.Medium1
Wikipedia gives SR20DET outputs from 204 PS (150 kW) to 250 PS (184 kW).Medium1
S14 T28 vs S15 T28
Owners report that S14 and non-Spec R turbos share part number 14411-69F00 and a single ball bearing.
The S15 Spec R unit uses dual ball bearings and a divided turbine housing.Low2
Garrett's catalog equivalent of the S15 unit is the GT2560R, which a New Zealand retailer lists with a 0.64 A/R turbine housing.Low6
Retailers list the S15 OEM unit as 14411-91F00. A replacement seller ties 14411-69F00 to the GT2560R as well, so check the tag and the housing divider rather than the number alone.Low352
What it supports
A tuning guide puts the late OEM T28 at around 280-300 hp at 1.3 bar (19 psi).
That is an owner-reported figure, not a Nissan rating, and depends on fuel, intercooling and calibration.Low7
Rebuilding a ball-bearing T28
The ball-bearing cartridge is pressed together, so owners replace the whole center cartridge rather than fitting new bearings.Low9
Use the roller-bearing oil drain gasket (Nissan 15196-69F00) on ball-bearing units; it does not fit journal-bearing turbos.Medium8
Common problems
What fails, why, and the usual fix.
1Shaft play or a rattle from a ball-bearing T28
Usual causeBearing wear in the pressed cartridge after high mileage or oil contamination.
FixReplace the complete center cartridge; the bearings are not serviced on their own.Low9
2Wrong turbo bought from a part number
Upgrade paths
The routes owners take from the factory unit.
S15 GT2560R onto an S14
S14 owners fit the S15 Spec R dual-ball-bearing unit. Owners report it shares the S14 mounting; check oil and water line fittings and the divided housing against the manifold.Low2
Garrett GT2871R bolt-on
A tuning guide describes a dual-ball-bearing GT2871R with a T25-style turbine inlet, S15-style compressor housing and internal wastegate as a direct bolt-on for S14 and S15 T28s.Low7
Garrett GTX2867R Gen II compressor map →Frequently asked
Is the S15 T28 a GT2560R?
Yes. Owners and retailers identify the S15 Spec R turbo as a dual-ball-bearing Garrett GT2560R, which one retailer lists with a 0.64 A/R turbine housing. It has a divider cast into the turbine housing that the S14 unit lacks.Low26
What is the difference between the S14 and S15 T28?
Owners report the S14 T28 uses a single ball bearing and an open turbine housing, while the S15 Spec R unit uses dual ball bearings and a divided housing. Part numbers differ too: 14411-69F00 for S14 and non-Spec R, and 14411-91F00 as listed for the S15.Low23
How much boost can a stock SR20DET T28 run?
Nissan does not publish a limit for extra boost. One tuning guide reports around 280-300 hp at 1.3 bar (19 psi) from a late OEM T28, but that depends on fuel, intercooler, exhaust and calibration. Log intake temperature and knock rather than chasing a number.Low7
Related
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
9 sources
- Nissan SR engine (SR20DET) · Wikipedia · reference · retrieved 2026-11-04
- S15 T28 questions · SR20 Forum · community · retrieved 2026-11-04
- ATP OEM SR20DET ball bearing T28 turbo for Nissan Silvia S15 · Vivid Racing · vendor-doc · retrieved 2026-11-04
- Garrett OEM S15 SR20DET T28 ball bearing turbo · TF-Works · vendor-doc · retrieved 2026-11-04
- 14411-69F00 GT2560R turbocharger replacement for Nissan SR20DET · LeadTurbo · vendor-doc · retrieved 2026-11-04
- Garrett GT2560R ball bearing turbo 0.64 A/R aka Nissan S15 T28 · Turbobits · vendor-doc · retrieved 2026-11-04
- Ultimate SR20DET turbo guide · Drifted · press · retrieved 2026-11-04
- Nissan 15196-69F00 turbo oil drain gasket (roller bearing) · JDM Garage UK · vendor-doc · retrieved 2026-11-04
- Where can I buy or rebuild a T28 BB turbo in SoCal · NICOclub · community · retrieved 2026-11-04
Brand and model names identify the turbo and the vehicles it was fitted to; GAINS is not affiliated with their makers.

