With ECU2
ECU2 supplies torque and handles the gearbox's torque-cut and blip requests, so shifts stay quick at high power.
GAINS PDM2 · Gearboxes · DQ500 DSG
VW / Audi · Dual-clutchThe seven-speed DSG for big power. Planned for v1 alongside the DQ250, through the factory mechatronic over CAN.
Audi RS3 / TT RS, VW Transporter T5 / T6 and Tiguan: the heavy-duty seven-speed wet dual-clutch.
| Audi 2.5 TFSI, big-turbo 2.0T, VR6 turbo | big-power transverse builds that outgrow the DQ250 |
|---|
Swap guides that use the DQ500 DSG:
The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.
ECU2 supplies torque and handles the gearbox's torque-cut and blip requests, so shifts stay quick at high power.
Same unlock rule as the DQ250: the buyer supplies an unlocked TCU where needed; GAINS never flashes it.
It is planned (v1 target). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.
Audi 2.5 TFSI, big-turbo 2.0T, VR6 turbo: big-power transverse builds that outgrow the DQ250.
No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. ECU2 supplies torque and handles the gearbox's torque-cut and blip requests, so shifts stay quick at high power.
No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.
Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. VW / Audi and other names identify compatible equipment only; GAINS is not affiliated with their makers.
Join the waitlist