GAINS PDM2 · Gearboxes · BMW M DCT (GS7D36SG, E9x M3)

Getrag (BMW) · Dual-clutch

BMW M DCT (GS7D36SG, E9x M3) swap controller: no separate DCT box

The dual-clutch swap of choice in time attack, now with adapter kits for LS, K, VQ, JZ and rotary. Planned for v1 through the factory TCU over CAN, so no separate DCT controller box.

ControlCAN to the factory TCU
StatusPlanned · v1 target
Gears7
Also calledBMW DCT swap, M-DCT, GS7D36
Common swaps

Where it ends up.

BMW E90 / E92 / E93 M3, the seven-speed M DCT.

GM LStime-attack and Pro Touring builds with LS-to-DCT adapter kits
Honda K24, Nissan VQ37, Toyota JZ, Mazda 13BS2000, S14, Miata endurance and time-attack cars

Swap guides that use the BMW M DCT (GS7D36SG, E9x M3):

CAN to the factory TCU

What PDM2 runs.

The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.

  • Private CAN bus to the factory TCU with the vehicle signals it expects (engine, wheel speeds, brake, cluster-type messages)
  • Paddle inputs and selector emulation
  • Battery and switched feeds

With ECU2

The factory TCU runs the clutches. ECU2 supplies torque and handles the shift blip and cut, which is what makes an M DCT feel right behind a swapped engine.

Good to know

The buyer supplies an immobilizer-unlocked TCU from an authorized tool; GAINS never flashes or unlocks it.

Good to know

Track use: plan for gearbox oil cooling, a known stress point in hot sessions.

FAQ
Can the GAINS PDM2 control a BMW M DCT (GS7D36SG, E9x M3)?

It is planned (v1 target). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.

Which swaps use the BMW M DCT (GS7D36SG, E9x M3)?

GM LS: time-attack and Pro Touring builds with LS-to-DCT adapter kits. Honda K24, Nissan VQ37, Toyota JZ, Mazda 13B: S2000, S14, Miata endurance and time-attack cars.

Does it need a separate transmission controller?

No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. The factory TCU runs the clutches. ECU2 supplies torque and handles the shift blip and cut, which is what makes an M DCT feel right behind a swapped engine.

Do you flash or unlock the factory TCU?

No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.

Related gearboxes

Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. Getrag (BMW) and other names identify compatible equipment only; GAINS is not affiliated with their makers.

Join the waitlist