With ECU2
As the gen 1 unit: the factory TCU runs the clutches; ECU2 supplies torque and shift interventions.
GAINS PDM2 · Gearboxes · BMW M DCT gen 2 (F80 / F82 M3 / M4)
Getrag (BMW) · Dual-clutchThe newer M DCT, rising fast in time attack. Planned for v2 after the gen 1 unit.
BMW F80 / F82 / F83 M3 and M4, M2 Competition, and the larger GS7D70SG in the F10 M5 and F1x M6.
| GM LS / LT, Toyota 2JZ, BMW S55 / S58 | time-attack and late Pro Touring builds |
|---|
Swap guides that use the BMW M DCT gen 2 (F80 / F82 M3 / M4):
The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.
As the gen 1 unit: the factory TCU runs the clutches; ECU2 supplies torque and shift interventions.
Needs a buyer-supplied unlocked TCU; GAINS never flashes or unlocks it.
It is planned (v2). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.
GM LS / LT, Toyota 2JZ, BMW S55 / S58: time-attack and late Pro Touring builds.
No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. As the gen 1 unit: the factory TCU runs the clutches; ECU2 supplies torque and shift interventions.
No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.
Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. Getrag (BMW) and other names identify compatible equipment only; GAINS is not affiliated with their makers.
Join the waitlist