With ECU2
The GR6 depends on a tight torque-request loop with the engine ECU; ECU2 must calculate and act on its requests.
GAINS PDM2 · Gearboxes · Nissan GR6 (R35 GT-R)
Nissan · Dual-clutchThe GT-R transaxle. Harder than the VW and BMW units because of its torque-request loop; on the roadmap.
Nissan R35 GT-R twin-clutch transaxle.
| Nissan VR38 and transplants (LS, K24) | GT-R based builds and a few transplant projects |
|---|
The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.
The GR6 depends on a tight torque-request loop with the engine ECU; ECU2 must calculate and act on its requests.
It is planned (Later). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.
Nissan VR38 and transplants (LS, K24): GT-R based builds and a few transplant projects.
No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. The GR6 depends on a tight torque-request loop with the engine ECU; ECU2 must calculate and act on its requests.
No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.
Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. Nissan and other names identify compatible equipment only; GAINS is not affiliated with their makers.
Join the waitlist