GAINS PDM2 · Gearboxes · DQ250 DSG

VW / Audi · Dual-clutch

DQ250 DSG swap controller: no separate DCT box

The most-swapped DSG. Today a DQ250 swap means an engine ECU plus a separate DSG controller box; ECU2 + PDM2 are planned to run it with no extra box, through the factory mechatronic over CAN.

ControlCAN to the factory TCU
StatusPlanned · v1 target
Gears6
Also calledDSG swap, 02E, DQ250 swap
Common swaps

Where it ends up.

VW Golf GTI / R Mk5 to Mk7, Audi TT and S3, Seat and Skoda: the six-speed wet dual-clutch.

VW / Audi 1.8T, 2.0T and VR6Golf, Jetta, Corrado and Audi builds, Mk1 to Mk4 restomods
Honda K-series and other transverse foursfront-drive and AWD conversions with adapter kits

Swap guides that use the DQ250 DSG:

CAN to the factory TCU

What PDM2 runs.

The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.

  • Private CAN bus to the factory mechatronic: engine torque, rpm, pedal, brake, wheel speeds and the chassis signals it expects
  • Paddle inputs and selector emulation
  • Battery and switched feeds to the mechatronic

With ECU2

The mechatronic keeps its clutch and shift control. ECU2 supplies an accurate torque model and acts on the gearbox's torque-cut and blip requests during each shift.

Good to know

Pre-MQB units (8P / PQ35 era) first. MQB units need the buyer to supply an immobilizer-unlocked TCU from an authorized tool; GAINS never flashes or unlocks it.

Good to know

Clutch relearn and adaptations are done with the usual VAG diagnostic tool.

FAQ
Can the GAINS PDM2 control a DQ250 DSG?

It is planned (v1 target). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.

Which swaps use the DQ250 DSG?

VW / Audi 1.8T, 2.0T and VR6: Golf, Jetta, Corrado and Audi builds, Mk1 to Mk4 restomods. Honda K-series and other transverse fours: front-drive and AWD conversions with adapter kits.

Does it need a separate transmission controller?

No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. The mechatronic keeps its clutch and shift control. ECU2 supplies an accurate torque model and acts on the gearbox's torque-cut and blip requests during each shift.

Do you flash or unlock the factory TCU?

No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.

Related gearboxes

Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. VW / Audi and other names identify compatible equipment only; GAINS is not affiliated with their makers.

Join the waitlist