GAINS PDM2 · Gearboxes · Mitsubishi TC-SST (Evo X)

Getrag (Mitsubishi) · Dual-clutch

Mitsubishi TC-SST (Evo X) swap controller: no separate DCT box

Mostly an Evo X keep-the-gearbox case rather than a swap. Later.

ControlCAN to the factory TCU
StatusPlanned · Later
Gears6
Also calledSST, Getrag 6DCT470, Evo X SST
Common swaps

Where it ends up.

Mitsubishi Lancer Evolution X and Ralliart.

Mitsubishi 4B11TEvo X owners keeping the SST on a standalone
CAN to the factory TCU

What PDM2 runs.

The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.

  • Private CAN bus to the factory TCU

With ECU2

ECU2 supplies the engine-side messages the SST TCU expects.

FAQ
Can the GAINS PDM2 control a Mitsubishi TC-SST (Evo X)?

It is planned (Later). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.

Which swaps use the Mitsubishi TC-SST (Evo X)?

Mitsubishi 4B11T: Evo X owners keeping the SST on a standalone.

Does it need a separate transmission controller?

No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. ECU2 supplies the engine-side messages the SST TCU expects.

Do you flash or unlock the factory TCU?

No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.

Related gearboxes

Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. Getrag (Mitsubishi) and other names identify compatible equipment only; GAINS is not affiliated with their makers.

Join the waitlist