WHP to HP calculator: drivetrain loss estimate

Estimated crank power = wheel power ÷ (1 − loss %), or wheel power = crank × (1 − loss %). The loss percentage is an assumption you choose, not a measured value. Enter a dyno figure to convert between wheel and crank estimates.

hp
%

Commonly assumed: about 12-15% manual RWD, 18-20% automatic, 20-25% AWD. These are conventions, not measurements, and real loss varies with the car and dyno.

hp

Some prefer a fixed loss plus a smaller percentage, because friction does not scale with power.

Result

Estimated crank power353 hp
Estimated wheel power300 hp
Loss between them53 hp
Effective loss15.0 %

Estimate only: drivetrain loss depends on the gearbox, differential, tyres, temperature, gear used and the dyno itself. Different dynos read the same car differently.

Planning estimate from the formula below, not a measurement.

How it works

The formula, the method step by step, then a worked example.

whp = hp × (1 − loss%) − fixed;  hp = (whp + fixed) ÷ (1 − loss%)
  1. A chassis dyno measures power at the wheels; engine ratings (SAE J1349) are at the crank.
  2. The difference is lost in the gearbox, driveline, differential and tyres.
  3. This calculator applies the loss you assume, as a percentage and optionally a fixed amount, in either direction.

Worked example

Inputs

Power figure
300 hp
This figure is
1
Assumed drivetrain loss
15 %
Fixed loss (optional)
0 hp

Result

Estimated crank power353hp
Estimated wheel power300hp
Loss between them53hp
Effective loss15.0%

Assumptions and limits

  • Labelled estimate: the loss percentage is an assumption. Published fixed percentages are rules of thumb, not standards.
  • Compare wheel figures only between runs on the same dyno, in the same gear, with the same correction standard.

Related terms

Frequently asked

How do I convert wheel horsepower to crank horsepower?

Divide wheel power by (1 − assumed loss). With 15% assumed loss, 300 whp is an estimated 353 hp at the crank. The loss figure is an assumption, so the result is an estimate, not a measurement.

What is a typical drivetrain loss?

Commonly quoted rules of thumb are about 12-15% for manual rear-wheel drive, 18-20% for automatics and 20-25% for all-wheel drive. These are conventions, not standards; real loss varies with the car, gear, temperature and dyno.

Is drivetrain loss a fixed percentage?

Not exactly. Some losses, such as bearing and seal friction, are closer to fixed, while others grow with load and speed. That is why the calculator also allows a fixed loss. Compare wheel figures on the same dyno instead of converting where you can.

Answers draw on the sources below.

Sources

  1. SAE J1349: Engine Power Test Code - Spark Ignition and Compression Ignition - As Installed Net Power Rating · SAE International · retrieved 2026-10-27
  2. Internal Combustion Engine Fundamentals (2nd ed.), ch. 2: engine performance parameters (bmep, typical maximum and rated-power values) · J. B. Heywood, McGraw-Hill, 2018

Spot an error? Tell us.