Injector dead time calculator
Total injector pulse width = effective pulse width + dead time at the current battery voltage. Enter the dead-time table and voltage to interpolate the offset, the pulse the ECU must command, and how lean the engine runs if it is ignored.
Result
Planning estimate from the formula below, not a measurement.
How it works
The formula, the method step by step, then a worked example.
PW_total = PW_effective + t_dead(V_batt); t_dead(V) = linear interpolation between table points; error if ignored = −t_dead ÷ PW_effective
- An injector does not open the instant it is energised; the delay minus the closing delay is its net dead time (offset).
- The delay is longer at low voltage, because current in the coil builds more slowly, so ECUs store it as a table against battery voltage.
- Interpolate between the two table points around the current voltage and add the result to the fuel-delivering pulse width.
Worked example
Inputs
- Battery voltage
- 13 V
- Effective pulse width (fuel-delivering)
- 5 ms
- Dead time at 8 V
- 1.9 ms
- Dead time at 10 V
- 1.25 ms
- Dead time at 12 V
- 0.9 ms
- Dead time at 14 V
- 0.7 ms
- Dead time at 16 V
- 0.56 ms
- Engine speed (optional, for duty cycle)
- 0 rpm
Result
Assumptions and limits
- Dead time also rises with differential fuel pressure; use a table measured at your pressure.
- Linear interpolation, holding the end values outside the table.
- Small-pulse non-linearity (below about 1-1.5 ms effective) needs a separate short-pulse correction.
Related terms
Frequently asked
What is injector dead time?
The delay between the ECU energising an injector and fuel actually flowing, net of the closing delay. It is mostly set by how fast current builds in the coil, so it grows at low battery voltage and with higher fuel pressure.
Why does injector dead time change with battery voltage?
The coil current rises more slowly at lower voltage, so the magnetic force needed to lift the pintle arrives later. That is why ECUs store dead time as a table against battery voltage and interpolate between points.
What happens if injector dead time is wrong?
Fuel errors are largest at short pulse widths, such as idle and cruise. In the example here, ignoring 0.8 ms of dead time on a 5 ms pulse leaves the engine about 16% lean. Errors also show up as mixture changes when charging voltage changes.
Answers draw on the sources below.
Sources
- SAE J1832: Low Pressure Gasoline Fuel Injector (static flow, dynamic flow and offset test procedures) · SAE International
- Automotive Handbook · Robert Bosch GmbH
- Internal Combustion Engine Fundamentals (2nd ed.) · J. B. Heywood, McGraw-Hill, 2018
Spot an error? Tell us.

