With ECU2
ECU2 supplies the engine messages; the factory TCU keeps its calibration and per-unit solenoid data.
GAINS PDM2 · Gearboxes · 10R80
Ford · AutomaticTen speeds behind a late Coyote. Planned for v2 through the factory TCU over CAN; direct control later.
2018 on Mustang GT and F-150 with an integrated TCU and per-unit solenoid characterization.
| Ford Coyote Gen 3 / 3.5 / 4 (port + direct injection) | Fox Mustang, F-100, Bronco and late restomods |
|---|
Swap guides that use the 10R80:
The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back.
ECU2 supplies the engine messages; the factory TCU keeps its calibration and per-unit solenoid data.
Each 10R80 carries unit-specific solenoid data, which is why the factory TCU stays in v2.
It is planned (v2). The factory TCU stays. PDM2 sends the engine-side messages it expects (torque, rpm, pedal, brake) on a private gearbox bus and reads gear and status back. Nothing is supported until bench and vehicle logs and an engineering review are done.
Ford Coyote Gen 3 / 3.5 / 4 (port + direct injection): Fox Mustang, F-100, Bronco and late restomods.
No separate controller box is planned: PDM2 handles the gearbox and ECU2 runs the engine. ECU2 supplies the engine messages; the factory TCU keeps its calibration and per-unit solenoid data.
No. The factory unit keeps its own calibration. Where an immobilizer unlock is needed, the buyer supplies an unlocked TCU from an authorized tool.
Planned capability, not a supported product. Shift control acts on engine output and is released only after bench and vehicle logs and a qualified engineering review. Ford and other names identify compatible equipment only; GAINS is not affiliated with their makers.
Join the waitlist