Key facts
Suits
- Four- and six-cylinder race engines needing two lambda channels and many PWM outputs
- Exposed mounting locations that need an IP66 case
- Builds planning a later move to direct injection
What it is and where it fits
The Syvecs S7-Plus is a general-purpose motorsport ECU from Syvecs of Farnborough, UK.
It covers engines up to 16 injectors with 6 ignition drivers, so wasted-spark or paired-coil strategies apply on engines with more than six cylinders.Medium12
Syvecs also sells plug-in kits for many Audi, VW, Nissan, Toyota and Porsche models. The S7-Plus is the stand-alone, wire-in route for custom builds.Medium23
Hardware and I/O
Sixteen low-side outputs rated 10 A serve as injector drivers or general PWM outputs.
Eight 10 A half-bridges handle electronic throttles, cam actuators and motors. Ignition uses 6 TTL/IGBT drivers.1
Twenty-two analog inputs split into bipolar-capable channels for crank, cam and speed signals and dedicated sensor and thermistor channels. Two onboard lambda inputs accept NTK, Bosch LSU 4.9 or Denso air-fuel sensors.1
The sealed billet case is IP66 rated, operates from -55 to +125 °C and measures 185 × 145 × 55 mm. Three waterproof connectors carry 94 pins.1
Software and configuration
The ECU runs Syvecs S7 firmware and is calibrated with Syvecs' SCal software.
Direct-injection control is sold as an optional upgrade rather than built into the base unit.1
Connectivity and expansion
Three CAN 2.0B buses, one LIN bus, RS232 and K-Line outputs cover dashes, expanders and OEM modules.
The third CAN bus shares pins with the first EGT input and is reserved for custom use.1
Programming and log download run over 100 Mbps Ethernet. Haltech lists Syvecs among the ECUs its iC-7 dash supports plug-and-play over CAN.14
Installation notes
Supply voltage runs 6-20 V DC with reverse polarity protection, and three protected 5 V outputs feed sensors.
Main relay control supports wake-up over CAN, useful when the car's network powers the system.1
Ignition drivers are TTL/IGBT, so check whether your coils have built-in igniters before wiring. The 55 mm case height is worth checking in tight under-dash spaces.Medium1
Generations and variants
Syvecs states the S7-Plus shipped with 32 MB of logging before May 2026 and 64 MB from May 2026, with 128 MB optional on compatible units. Check the build date when buying used.1
Specifications
From the maker's published data and independent sources.
Outputs
Inputs
Communication
Strengths and limits
Facts, each cited. Not a score.
Strengths
Often compared with
| Product | Category | Key fact |
|---|---|---|
| MoTeC M150 | Standalone ECUs | Injector outputs: 12 peak and hold + 6 low-side |
| Emtron KV8 | Standalone ECUs | Injector / ignition outputs: 8 / 8 |
| Link G5 Voodoo Neo 6 | Standalone ECUs | Injection / ignition drives: 12 / 8 |
| Haltech Nexus R5 VCU | Standalone ECUs | Injector / ignition outputs: 18 / 12 |
| ECUMaster EMU PRO-8 | Standalone ECUs | Outputs / inputs: 31 / 24 |
| MaxxECU RACE | Standalone ECUs | Injector / ignition outputs: 8 peak and hold (8 A) / 8 |
Frequently asked
How many injectors can a Syvecs S7 run?
The S7-Plus has 16 low-side injection/PWM outputs rated 10 A each, so it can drive up to 16 injectors, for example staged injection on an eight-cylinder. Outputs not used for injectors can run solenoids or other PWM loads instead. Ignition is the tighter limit, at six drivers.1
Does the Syvecs S7 have built-in wideband?
Yes. Syvecs lists two lambda inputs that accept NTK, Bosch LSU 4.9 or Denso AF sensors. That covers closed-loop fueling on each bank of a V engine without external lambda modules, and it gives a choice of sensor brand. Each input still needs its own sensor and harness run.1
What software does Syvecs use?
The S7-Plus runs Syvecs S7 firmware and is calibrated with Syvecs' SCal software. The PC connects over 100 Mbps full-duplex Ethernet, which Syvecs uses for programming, calibration and data download. A standard Ethernet port on the laptop or a USB adaptor covers the connection, and the harness must bring the Ethernet pins out to a suitable plug.1
Can the Syvecs S7 run direct injection?
Only with an upgrade. Syvecs lists direct-injection control as an optional upgrade for the S7-Plus. Budget for it at purchase if the engine is DI, and confirm the high-pressure pump and injector driver arrangement with Syvecs or a dealer. Port-injected engines do not need it.1
How much logging memory does the Syvecs S7 have?
Syvecs states 32 MB on units built before May 2026 and 64 MB from May 2026, with a 128 MB option on compatible units. A used ECU may therefore have half the memory of a new one, so check the build date or ask the seller.1
Related terms
Sources
Numbered as cited above. Hover or tap a citation chip to preview it.
- S7-Plus product page · Syvecs · vendor-doc · retrieved 2026-11-04
- Syvecs home page (company address, product categories) · Syvecs · vendor-doc · retrieved 2026-11-04
- ECU plug and play kits index · Syvecs · vendor-doc · retrieved 2026-11-04
- HT-067010 Haltech iC-7 Digital Dash Kit product page (ECU compatibility list) · Haltech · vendor-doc · retrieved 2026-11-04
A technical overview from published sources; we have not tested this product. Product names are the property of their owners and identify the product only; GAINS is not affiliated with, or endorsed by, the maker.

