Ford Modular · 2005-10

4.6 3V specs: horsepower, injectors and sensors

The 4.6 3V (VCT) is a naturally aspirated 4.6 L V8 engine from Ford (2005-10) with port fuel injection and coil-on-plug ignition. Below: factory specification and ratings, sensor part numbers, OEM injectors and direct-fit upgrades, triggers, swaps and tuning notes, each with its evidence.Medium124957

Power: 300 hp @ 5,750 rpm · Torque: 320 lb-ft (434 Nm) @ 4,500 rpm (Ford rating, not a GAINS measurement)Medium124

Factory specification

Layout, dimensions and factory hardware, each with its source.

Production years2005-10Catalog range across the variants on this page.Researched, unverified
Displacement4.6L4,601 cc from bore × strokeSourced · medium124
LayoutV8Researched, unverified
Bore × stroke90.2 × 90mm3.55 × 3.54 inSourced · medium124
Redline6,250rpmSourced · medium124
Aspirationnaturally aspiratedResearched, unverified
Fuel injectionport fuel injectionSourced · medium957
Block
  • Aluminium2005-10 Mustang GT
  • Cast irontrucks
Low confidence124
Main capscross-boltedfamilyLow confidence124

Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.

4.6 3V horsepower and torque

Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.

Power (Ford rating)300hp @ 5,750 rpmSAE net, 2005-09 Mustang GT; rpm points and 6250 redline from third-party spec tables (Steeda), not an OEM document seenSourced · medium124
Torque (Ford rating)320 lb-ft @ 4,500 rpm434 NmSourced · medium124
Other published ratings
  • 2010 Mustang GT: 315 hp, 325 lb-ft (rpm not confirmed)
  • Pre-release reports cited 315 lb-ft for 2005
Sourced · medium124

4.6 3V firing order

4.6 3V injectors

The factory injector, then direct-fit upgrades the makers list for this engine.

Factory injector

StyleEV6Sourced · medium957
MakerBoschSourced · medium957
Flow252cc/minconverted from 24 lb/hrSourced · medium957
ImpedancehighsaturatedSourced · medium957
ConnectorEV6 / USCARSourced · medium957
LengthstandardID code 60 mmSourced · medium957
FeedtopSourced · medium957
O-ring OD (top / bottom)14/ 14 mmSourced · medium957

Direct-fit upgrades

Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.

InjectorFlowFit
DeatschWerks 1000cc EV14 injectors (set of 8) · 17U-04-0095-8Medium81000 cc/min maker listing (basis not stated)Check connector Connector fit not stated on the maker listing.
Fuel Injector Clinic (FIC) FIC 525cc High-Z injector set · IS403-0525H17525 cc/min cc/min @ 3 bar (43.5 psi), CF-16B calibration fluid, 90 F (maker rating)Plug-in
Fuel Injector Clinic (FIC) FIC 1000cc High-Z injector set · IS403-1000H171000 cc/min cc/min @ 3 bar (43.5 psi), CF-16B calibration fluid, 90 F (maker rating)Plug-in
Injector Dynamics ID1050-XDS (set) · 1050.60.14.14.851012141065 cc/min cc/min @ 3.0 bar (43.5 psi), gasoline at 52 C (maker spec)Plug-in
Injector Dynamics ID1300-XDS (set) · 1300.60.14.14.861113151335 cc/min cc/min @ 3.0 bar (43.5 psi), iso-octane at 52 C (maker spec)Plug-in

Sensors

Factory sensors by role: part numbers, signal type and fitment years.

SensorOEM part numbersType / signalYears and markets
Crank positionFord 1W7Z-6C315-ABSourced · medium16Not yet sourced2005-10
Cam positionFord 1W7Z-6B288-ABSourced · medium16Not yet sourced2005-10
KnockFord 1L2Z-12A699-AA (2005-07, dual-headed bolt-on) | 4L3Z-12A699-AA (2007-10)Sourced · medium16dual-headed bolt-on (1L2Z)Mustang 4.6 SOHC
MAFFord 3L3Z-12B579-BASourced · medium16Not yet sourced2005-10 Mustang 4.0/4.6/5.4SC
O2 (upstream)Ford 5C5Z-9F472-AA (-> GU2Z-9G444-A)Low confidence16Not yet sourced2005-10 Mustang
O2 (downstream)Ford XR3Z-9G444-HA (2005-06) | XR3Z-9G444-JA (2006-09)Sourced · medium16Not yet sourced

Ignition and triggers

Ignition systemcoil-on-plugResearched, unverified
Crank triggerOEM sensor Ford 1W7Z-6C315-AB2005-10Sourced · medium16
Cam sensorOEM sensor Ford 1W7Z-6B288-AB2005-10Sourced · medium16
Valve timingcam VCT2 phasersResearched, unverified

Tuning notes

Factory load sensing

Ford Racing 2007-09 4.6/5.4 3V ETC controls pack uses production Mustang HEGO for closed-loop feedback. MAF not confirmed from this sheet (cold air kit required).Medium3

Factory oxygen sensors

Upstream: narrowband (zirconia) (HEGO). Downstream O2 sensors: yes. Closed-loop fuelling: narrowband (HEGO) closed loop; open loop at high load.Medium3

Injector drive

Factory injector impedance: high (saturated). Connector: EV6 / USCAR.Medium957

Driver and calibration

High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified

Known limits (reported)

No 3V-specific limit source found.Low124

Valvetrain, factory engine management and weak points across every generation are on the Ford Modular guide.

Vehicles with the 4.6 3V (VCT)

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

17 sources
  1. Factory ratings: Ford Modular 4.6 2V (E-705) · en.wikipedia.org · reference · retrieved 2026-10-25
  2. Factory ratings: Ford Modular (4.6 3V, 4.6/5.4 4V) (E-706) · en.wikipedia.org · reference · retrieved 2026-10-25
  3. Ford 4.6/5.4 3V O2 (E-806) · performanceparts.ford.com · oem · retrieved 2026-10-25
  4. Ford Modular 2V/3V/4V/5.4 (E-1014) · en.wikipedia.org · reference · retrieved 2026-10-25
  5. Injector aftermarket fitment (E-1200) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  6. Injector aftermarket fitment (E-1201) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  7. Injector aftermarket fitment (E-1205) · fuelinjectorclinic.com · vendor-doc · retrieved 2026-10-25
  8. Injector aftermarket fitment (E-1208) · nipponpower.com · reference · retrieved 2026-10-25
  9. OEM injector (E-1212) · onallcylinders.com · press · retrieved 2026-10-25
  10. Injectors / ID1050-XDS fitment (E-1230) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  11. Injectors / ID1300-XDS fitment (E-1231) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  12. Injector Dynamics ID1050-XDS fitment table (E-1260) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  13. Injector Dynamics ID1300/ID1750/ID2600 fitment tables (E-1261) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  14. Injector Dynamics ID1050-XDS fitment table (E-1290) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  15. Injector Dynamics ID1300-XDS fitment table (E-1291) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  16. OEM sensors Ford Mustang (E-1327) · fordpartsgiant.com · vendor-doc · retrieved 2026-10-25
  17. fuelinjectorclinic.com product listing · fuelinjectorclinic.com · vendor-doc · retrieved 2026-10-25

Evidence ids (E-…) refer to our research register; each records the source, date and confidence.