GM small-block Gen I / Gen II · 1985-02

350 Vortec specs: horsepower, firing order, injectors and sensors

The SBC 350 (L98 TPI / L31 Vortec) is a naturally aspirated 5.7 L V8 engine from GM (1985-02) with port fuel injection and distributor ignition. Its firing order is 1-8-4-3-6-5-7-2. Factory load sensing changes with year and market. Below: factory specification and ratings, sensor part numbers, OEM injectors and direct-fit upgrades, triggers, swaps and tuning notes, each with its evidence.Low18924 Conflict

Power: 255 hp @ 4,600 rpm · Torque: 330 lb-ft (447 Nm) @ 2,800 rpm (GM rating, not a GAINS measurement)Low1

Factory specification

Layout, dimensions and factory hardware, each with its source.

Production years1985-02Catalog range across the variants on this page.Researched, unverified
Displacement5.7L5,733 cc from bore × strokeConflict1
LayoutV8Researched, unverified
Bore × stroke101.6 × 88.4mm4.00 × 3.48 inConflict1
Compression ratio9.4:1Conflict1
Aspirationnaturally aspiratedResearched, unverified
Fuel injectionport fuel injectionLow confidence4
Blockcast ironper OE-reman/crate listingsLow confidence3
Cylinder linersnoneiron blockLow confidence3
Main caps

2-bolt or 4-bolt depending on block casting (retail listings conflict)

Low confidence3
Crankshaft

listings conflict: OE cast (reground) crank per OE-reman listing vs forged 1053 steel on one crate listing

Low confidence3
Connecting rodspowdered metal, 5.7 inVortec L31 crate listingLow confidence3
Pistons

hypereutectic with graphite-coated skirts (Vortec L31 crate listing)

Low confidence3

Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.

350 Vortec horsepower and torque

Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.

Power (GM rating)255hp @ 4,600 rpmPrimary = L31 Vortec 5700 (1996-2002 GM trucks), SAE net. Bore x stroke 4.00 x 3.48 in. Peak rpm per Wikipedia engine table; 330 lb-ft is most-cited (one listing says 335).Conflict1
Torque (GM rating)330 lb-ft @ 2,800 rpm447 NmConflict1
Other published ratings
  • L98 TPI Corvette: 1985-86 230 hp
  • 1987-89 240 hp245 w/ 3.07 axle 88-89
  • 1990-91 245 hp (250 w/ 3.07 axle) - 1990 rpm figures conflict: 245 hp @4300 / 340 lb-ft @3200 vs Corvsport 250 hp @4400 / 350 lb-ft @3200
  • L98 F-body: 225-245 hp, 330-345 lb-ft1987-92 Camaro/Firebird
  • L98 CR 9.5 (F-body) / 10.01990+ Corvette per Wikipedia; Corvsport lists 9.5 for 1990 Corvette
  • L31 family range 255-350 hp per Wikipedia (higher figures = marine/crate, not OEM truck)
  • L98 redline ~5000 implied by C4 docs (LT1 5700 = 700 above L98)
Conflict1

350 Vortec firing order

The order the cylinders fire in, with the cylinder numbering the source states.

  1. 1
  2. 8
  3. 4
  4. 3
  5. 6
  6. 5
  7. 7
  8. 2
  9. Medium89Sourced · medium
FRONTLeft (driver) bank11345677Right (passenger) bank28436582
Top view, front of the engine at the top. Small badges show each cylinder's place in the firing sequence. Numbered front to back: odd cylinders on the left (driver-side) bank, even on the right. Distributor turns clockwise.

350 Vortec injectors

The factory injector, then direct-fit upgrades the makers list for this engine.

Factory injector

Style
  • EV1 (Jetronic)TPI
  • L31 Vortec: CSFI poppet-nozzle spider (not a conventional port injector)
Low confidence4
MakerBoschTPI original multi-point injector per EngineLabsLow confidence4
ConnectorEV1 / JetronicTPILow confidence4
Lengthstandardtallest GM injectorLow confidence4
FeedtopLow confidence4

Sensors

Factory sensors by role: part numbers, signal type and fitment years.

SensorOEM part numbersType / signalYears and markets
Crank positionGM 12596851 (repl 10456607, 10456532, 12562910)Sourced · medium7Not yet sourced1996-99 C1500 4.3/5.0/5.7 (L31 Vortec)TPI L98 used distributor pickup; no separate crank sensor listed for 1985-92
Cam positionGM 19417445 kit (repl 10490645, 10485432)Low confidence7Not yet sourced1996-99 C1500 4.3/5.0/5.7Catalogue lists it under crankshaft page as Sensor ASM, CM/SHF POSN (Kit); L31 cam signal is in distributor
KnockGM 10456288 (repl 10456018)Sourced · medium567Not yet sourced1987-89 Camaro/Corvette 5.7; 1988-99 C/K 1500 5.0/5.7Corvette 1985-91 also lists GM 10456549; 1990 Corvette lists 10456075. Catalogue calls some entries ESC sensor
MAPGM 12569240 (repl 16254719, 16137039) | GM 19418808 (L31 1996-99 trucks)Sourced · medium567Not yet sourced12569240: 1988-97 Camaro 5.0/5.7, 1988-98 C1500; 19418808: 1996-99 C1500 4.3/5.0/5.7Corvette 1990-95 5.7 lists 16231141 (manifold differential pressure)
MAFGM 14081243 | GM 14094712 | GM 10055877Sourced · medium56Not yet sourced1985-89 Camaro 5.0/5.7 TPI; Corvette 1985-91L98 TPI only; L31 Vortec trucks are speed-density (no MAF listed in C1500 catalogue)
O2 (upstream) × 1 (pre-1996 single sensor after manifold); 1996+ OBD-II four sensors, two pre-catGM 19211437 (TPI era) | GM 19178934 / 19178918 (L31 1996-99)Low confidence567Not yet sourced19211437: 1982-95 Camaro, 1984-91 Corvette, 1988-95 C1500; 19178934/19178918: 1996-99 C1500 5.0/5.7Catalogue does not state position for the 1996-99 truck parts; count from catalogue note

Ignition and triggers

Ignition systemdistributorResearched, unverified
Crank triggerOEM sensor GM 12596851repl 10456607, 10456532, 125629101996-99 C1500 4.3/5.0/5.7 (L31 Vortec)Sourced · medium7
Cam sensorOEM sensor GM 19417445 kitrepl 10490645, 104854321996-99 C1500 4.3/5.0/5.7Low confidence7
Valve timingnonepushrodResearched, unverified

Tuning notes

Factory load sensing

The factory ECU measures load by a strategy that changes with year and market. TPI: MAF 1985-89 (1985 frequency MAF, 1986-89 analog), MAP speed-density 1990-92 (Corvette/F-body); L31 Vortec 1996-02 strategy not sourced. O2 type/count not sourced.Low2

Factory oxygen sensors

Downstream O2 sensors: no (pre-1996) / yes (1996+ OBD-II).Low2

Injector drive

Connector: EV1 / Jetronic (TPI).Low4

Driver and calibration

High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified

Known limits (reported)

No OEM or press limit source found; component facts come from Chevrolet Performance/OE-reman crate listings at retailers. Inference only: powdered-metal rods and hypereutectic pistons are the parts most likely to limit power.Low3

Valvetrain, factory engine management and weak points across every generation are on the GM small-block Gen I / Gen II guide.

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

9 sources
  1. Factory ratings: GM small-block Gen I/II (L98, L31, LT1) (E-700) · en.wikipedia.org · reference · retrieved 2026-10-25
  2. GM TPI load strategy (E-800) · forums.corvetteactioncenter.com · community · retrieved 2026-10-25
  3. SBC L31 internals (E-1011) · jegs.com · vendor-doc · retrieved 2026-10-25
  4. OEM injector (E-1210) · enginelabs.com · press · retrieved 2026-10-25
  5. OEM sensors GM Camaro (E-1320) · gmpartsgiant.com · vendor-doc · retrieved 2026-10-25
  6. OEM sensors GM Corvette (E-1321) · gmpartsgiant.com · vendor-doc · retrieved 2026-10-25
  7. OEM sensors GM C1500 (E-1324) · gmpartsgiant.com · vendor-doc · retrieved 2026-10-25
  8. Firing order: Chevrolet small block Gen I/II (E-4802) · help.summitracing.com · vendor-doc · retrieved 2026-10-28
  9. Firing order: Chevrolet small block (crate engine instructions) (E-4803) · static.speedwaymotors.com · reference · retrieved 2026-10-28

Evidence ids (E-…) refer to our research register; each records the source, date and confidence.