Mazda rotary (13B / Renesis) · 2004-12

13B-MSP Renesis specs: horsepower, injectors and sensors

The 13B-MSP Renesis (RX-8) is a naturally aspirated 1.3 L 2-rotor rotary engine from Mazda (2004-12) with port fuel injection and coil-on-plug ignition. The factory ECU measures load by MAF. Below: factory specification and ratings, sensor part numbers, OEM injectors and direct-fit upgrades, triggers, swaps and tuning notes, each with its evidence.Low1210

Power: 232 hp @ 8,500 rpm · Torque: 159 lb-ft (216 Nm) @ 5,500 rpm (Mazda rating, not a GAINS measurement)114

Factory specification

Layout, dimensions and factory hardware, each with its source.

Production years2004-12Catalog range across the variants on this page.Researched, unverified
Displacement1.3LResearched, unverified
Layout2-rotor rotaryResearched, unverified
Compression ratio10.0:1Conflict114
Redline9,000rpmConflict114
Aspirationnaturally aspiratedResearched, unverified
Recommended fuel91AKI premiumConflict114
Fuel injectionport fuel injectionLow confidence1210
Block

rotary: side-exhaust ports with extra side-housing water jacket (Wikipedia)

Conflict12315
Cylinder linersn/arotaryConflict12315
Connecting rodsn/arotaryConflict12315
Pistons

low-height apex seals, redesigned side seals, second cut-off ring (Wikipedia)

Conflict12315

Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.

13B-MSP Renesis horsepower and torque

Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.

Power (Mazda rating)232hp @ 8,500 rpmMazda USA spec deck, SAE net, 6-port manual; rotary 2 x 654 cc so bore/stroke n/aConflict114
Torque (Mazda rating)159 lb-ft @ 5,500 rpm216 NmConflict114
Other published ratings
  • 4-port automatic: 212 hp @7500, 159 lb-ft @5500, redline 7500
  • Original 2004 US advertised 238 hp (re-rated)
  • Renesis II (2009+) per Wikipedia: 6-port 232 hp @8500, 4-port 212 hp @7500, 216 Nm @5500
  • EU: 231 PS / 192 PS
Conflict114

13B-MSP Renesis firing order

13B-MSP Renesis injectors

The factory injector, then direct-fit upgrades the makers list for this engine.

Factory injector

StyleTop-feed, 3 per rotorP1, P2, secondaryLow confidence1210
OEM part numbers195500-4430seller listingLow confidence1210
MakerDensoLow confidence1210
Impedancehigh (saturated), 13.8 (seller listing) ΩLow confidence1210
LengthotherLow confidence1210
FeedtopLow confidence1210

Direct-fit upgrades

Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.

InjectorFlowFit
Injector Dynamics ID1050-XDS (RX-8 03-11 secondaries only) pair · 1050.60.11.D.2468101065 cc/min 3.0 bar (43.5 psi), gasoline, 52 C (maker spec)Needs adapter USCAR-to-OEM plug adapter (sold separately)
Injector Dynamics ID1300-XDS (RX-8 03-11 secondaries only) pair · 1300.60.11.D.2579111335 cc/min 3.0 bar (43.5 psi), iso-octane, 52 C (maker spec)Needs adapter USCAR-to-OEM plug adapter (sold separately)

Sensors

Factory sensors by role: part numbers, signal type and fitment years.

SensorOEM part numbersType / signalYears and markets
Crank position × 1N3A1-18-221ALow confidence13eccentric shaft position sensorRX-8 (listing)Mecatechnic listing; eBay listing calls N3A1-18-221 camshaft sensor
KnockNot yet sourcedCross-ref: Carquest SBC3933 (2006/2009 RX-8)Low confidence13piezo knock sensorOEM number not sourced
MAPNot yet sourcedResearched, unverifiedNot yet sourced
MAF × 1Not yet sourcedResearched, unverifiedhot-wireNot sourced
O2 (upstream) × 1N3H1-18-8G1BSourced · medium13Denso front lambdaRX-8 SE 2003-08

Ignition and triggers

Ignition systemcoil-on-plugResearched, unverified
Crank triggereccentric shaft position sensorRX-8 (listing)Low confidence13
Valve timingrotary, 6 injectorsResearched, unverified

Tuning notes

Factory load sensing

The factory ECU measures load by MAF (hot-wire / hot-film). Mazda MAF part L321-13-215 for 2004-11 RX-8 (parts listing); front exhaust-manifold sensor N3H1-18-8G1B (Denso) listed, but type (narrowband vs A/F) not confirmed. Researched, unverified

Injector drive

Factory injector impedance: high (saturated).Low1210

Driver and calibration

High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified

Known limits (reported)

Low compression from apex seal wear commonly reported, attributed to low-height seals and insufficient oil metering (Martiniworks, forum).Low12315 Conflict

Valvetrain, factory engine management and weak points across every generation are on the Mazda rotary (13B / Renesis) guide.

Vehicles with the 13B-MSP Renesis (RX-8)

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

15 sources
  1. Factory ratings: mazda-rotary (E-744) · en.wikipedia.org · reference · retrieved 2026-10-25
  2. Mazda 13B rotary (FC/FD) (E-1101) · en.wikipedia.org · reference · retrieved 2026-10-25
  3. Mazda Renesis (E-1102) · en.wikipedia.org · reference · retrieved 2026-10-25
  4. Injector aftermarket fitment (E-1200) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  5. Injector aftermarket fitment (E-1201) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  6. Injectors / ID1050-XDS fitment (E-1230) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  7. Injectors / ID1300-XDS fitment (E-1231) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  8. Injector Dynamics ID1050-XDS fitment table (E-1260) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  9. Injector Dynamics ID1300/ID1750/ID2600 fitment tables (E-1261) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  10. Injector Dynamics ID1050-XDS fitment table (E-1290) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  11. Injector Dynamics ID1300-XDS fitment table (E-1291) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  12. RX-8 Renesis injectors (E-1307) · tre.dev.webshopmanager.com · reference · retrieved 2026-10-25
  13. Sensors/Mazda RX-8 (E-1431) · mecatechnic.com · reference · retrieved 2026-10-25
  14. Swap guide ls-swap-mazda-rx8 (E-3449) · en.wikipedia.org · reference · retrieved 2026-10-27
  15. OEM turbo: mazda-rx7-hitachi-ht18 (E-10105) · en.wikipedia.org · reference · retrieved 2026-11-04

Evidence ids (E-…) refer to our research register; each records the source, date and confidence.