Subaru FA · 2015-

FA20DIT specs: horsepower, injectors and sensors

The FA20DIT / FA24DIT (WRX) is a turbocharged 2.0 L flat-4 engine from Subaru (2015-) with direct injection and coil-on-plug ignition. The factory ECU measures load by MAF. Below: factory specification and ratings, sensor part numbers, OEM injectors and direct-fit upgrades, triggers, swaps and tuning notes, each with its evidence.Medium14523867

Power: 268 hp @ 5,600 rpm · Torque: 258 lb-ft (350 Nm) @ 2,000 rpm (Subaru rating, not a GAINS measurement)Medium145

Factory specification

Layout, dimensions and factory hardware, each with its source.

Production years2015-Catalog range across the variants on this page.Researched, unverified
Displacement2.0L1,998 cc from bore × strokeSourced · medium145
Layoutflat-4Researched, unverified
Bore × stroke86 × 86mm3.39 × 3.39 inSourced · medium145
Compression ratio10.6:1Sourced · medium145
Redline6,700rpmSourced · medium145
AspirationturbochargedResearched, unverified
Recommended fuelpremium unleadedSourced · medium145
Fuel injectiondirect injectionSourced · medium67
BlockaluminiumFA24 all-aluminium per WikipediaLow confidence145
Connecting rodsoffset rodsJE PistonsLow confidence145
PistonscastJE PistonsLow confidence145

Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.

FA20DIT horsepower and torque

Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.

Power (Subaru rating)268hp @ 5,600 rpmSAE net, US 2015-21 WRX FA20DIT; torque plateau 2000-5200 rpm; redline per Wikipedia (citing comeanddriveit)Sourced · medium145
Torque (Subaru rating)258 lb-ft @ 2,000 rpm350 NmSourced · medium145
Other published ratings
  • FA24DIT (2022+ US WRX): 271 hp @5600, 258 lb-ft @2000-5200 (Wikipedia lists 2000-4800; conflict), bore 94 x stroke 86 mm, 10.6:1, premium fuel per third-party spec table350 Nm
  • JDM WRX S4 FA20DIT: 300 PS @5600, 400 Nm @2000-4800
  • JDM WRX S4 FA24: 275 PS, 375 Nm
Sourced · medium145

FA20DIT firing order

FA20DIT injectors

The factory injector, then direct-fit upgrades the makers list for this engine.

Factory injector

StyleGDIdirect injection, solenoidSourced · medium67
ImpedanceDIhigh-voltage solenoid driveSourced · medium67
LengthotherSourced · medium67

Direct-fit upgrades

Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.

InjectorFlowFit
Nostrum Upgraded Direct Injector Kit 2015-2021 WRX / 2014-2018 Forester XT (FA20F) · H720-1813Medium6not stated 15.7 g/s at 100 bar (vendor listing); ~+10% vs stockPlug-in tune required
Nostrum Upgraded Direct Injectors 2022+ WRX / Ascent / Legacy XT / Outback XT (FA24)Medium7not stated ~+24% vs stock (vendor listing)Plug-in tune required

Sensors

Factory sensors by role: part numbers, signal type and fitment years.

SensorOEM part numbersType / signalYears and markets
Knock × 122060AA160 -> 22060AA180 (TSB 07-133-18R)Sourced · medium9flat non-resonant piezo2015-17 WRXOriginal sensor heat durability issue; TSB revised part
MAP × 122627AA490 (supersedes 22627AA440)Sourced · medium8absolute pressure sensor · 0-5 V analog2015-2020 WRX (catalogue engine label wrong)
MAF × 122680AA410 (2015 WRX 2.0)Sourced · medium8hot-film2015 WRXFA24DIT number not sourced
O2 (upstream) × 122641AA650|22641AA720Sourced · medium8wideband A/F sensor · current (A/F)2015 WRX

Ignition and triggers

Ignition systemcoil-on-plugResearched, unverified
Valve timingdual AVCSResearched, unverified

Tuning notes

Factory load sensing

The factory ECU measures load by MAF (hot-wire / hot-film). OEM parts catalog 2015 WRX 2.0L: air flow meter 22680AA410, Air/Fuel Ratio sensor 22641AA650, rear oxygen 22690AB010. FA24DIT (2022+) not checked. Whether the ECU blends MAP into load not sourced.Medium238

Factory oxygen sensors

Upstream: wideband A/F (UEGO) (1). Downstream O2 sensors: yes.Medium238

Injector drive

Factory injector impedance: DI (high-voltage solenoid drive).Medium67

Driver and calibration

High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified

Known limits (reported)

Rods commonly cited as first failure, bending under high low-rpm torque (JE Pistons, 8020/Crawford); cast pistons secondary.Low145

Common first upgrades (reported)

Builders most often report upgrading: forged H-beam rods and forged pistons, closed-deck conversion (Crawford, JE).Low145

Valvetrain, factory engine management and weak points across every generation are on the Subaru FA guide.

Vehicles with the FA20DIT / FA24DIT (WRX)

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

9 sources
  1. Factory ratings: subaru-fa (E-740) · subaru.co.jp · oem · retrieved 2026-10-25
  2. Subaru EJ255/EJ257 fueling (E-847) · subarupartsdeal.com · vendor-doc · retrieved 2026-10-25
  3. Subaru FA20DIT fueling (E-848) · subarupartsdeal.com · vendor-doc · retrieved 2026-10-25
  4. Subaru/Toyota FA internals and limits (E-1047) · en.wikipedia.org · reference · retrieved 2026-10-25
  5. Subaru FA20DIT internals (E-1097) · en.wikipedia.org · reference · retrieved 2026-10-25
  6. Nostrum FA20F DI injectors (E-1297) · subimods.com · reference · retrieved 2026-10-25
  7. Nostrum FA24 DI injectors (E-1298) · subimods.com · reference · retrieved 2026-10-25
  8. Sensors/Subaru WRX STI MAF MAP AFR (E-1422) · subarupartsdeal.com · vendor-doc · retrieved 2026-10-25
  9. Sensors/Subaru FA20DIT knock TSB (E-1423) · go-parts.com · vendor-doc · retrieved 2026-10-25

Evidence ids (E-…) refer to our research register; each records the source, date and confidence.