Ford Duratec · 2005-10

Duratec ST 2.5T specs: horsepower, injectors and sensors

The Duratec ST 2.5T (5-cyl) is a turbocharged 2.5 L inline-5 engine from Ford/Volvo (2005-10) with port fuel injection and coil-on-plug ignition. Below: factory specification and ratings, sensor part numbers, OEM injectors and direct-fit upgrades, triggers, swaps and tuning notes, each with its evidence.Low121446

Power: 222 hp @ 6,100 rpm · Torque: 236 lb-ft (320 Nm) @ 1,600 rpm (Ford/Volvo rating, not a GAINS measurement)Medium1214

Factory specification

Layout, dimensions and factory hardware, each with its source.

Production years2005-10Catalog range across the variants on this page.Researched, unverified
Displacement2.5L2,521 cc from bore × strokeSourced · medium1214
Layoutinline-5Researched, unverified
Bore × stroke83 × 93.2mm3.27 × 3.67 inSourced · medium1214
Compression ratio9.0:1Sourced · medium1214
AspirationturbochargedResearched, unverified
Fuel injectionport fuel injectionLow confidence46

Facts tagged “Researched, unverified” come from our engine catalog without a cited source yet.

Duratec ST 2.5T horsepower and torque

Ratings as the manufacturer published them, with their basis. They are not GAINS measurements or tuning results.

Power (Ford/Volvo rating)222hp @ 6,100 rpmConverted from DIN 225 PS (x0.9863); Ford UK 2005 Focus ST release: 225 PS @6100, 320 Nm from 1600 (plateau 1600-4000 per GoAuto); bore/stroke/CR from Volvo B5254T3 base engineSourced · medium1214
Torque (Ford/Volvo rating)236 lb-ft @ 1,600 rpm320 NmSourced · medium1214
Other published ratings
  • 2009-10 Focus RS Mk2 (Duratec RS, lower CR): 305 PS @6500, 440 Nm @2300-4500300 bhp
  • Volvo B5254T3: 220 PS @5000, 320 Nm @1500-4800
Sourced · medium1214

Duratec ST 2.5T firing order

Duratec ST 2.5T injectors

The factory injector, then direct-fit upgrades the makers list for this engine.

Factory injector

StyleEV14-type top-feedID code 48 mmLow confidence46
ImpedancehighsaturatedLow confidence46
ConnectorEV6 / USCARinferred from ID USCAR kit listed without adapterLow confidence46
LengthstandardID code 48 mmLow confidence46
FeedtopLow confidence46
O-ring OD (top / bottom)14/ 14 mmLow confidence46

Direct-fit upgrades

Sets the maker lists for this engine. Fit is the maker’s own statement; flow is the maker’s rating and test basis.

InjectorFlowFit
DeatschWerks Set of 5 440cc injectors · 18U-09-0440-5Low15440 cc/min maker listing (basis not stated)Check connector Connector fit not stated on the maker listing.
Injector Dynamics ID1050-XDS (set) · 1050.48.14.14.5Medium479111065 cc/min cc/min @ 3.0 bar (43.5 psi), gasoline at 52 C (maker spec)Plug-in
Injector Dynamics ID1300-XDS (set) · 1300.48.14.14.5Medium5810121335 cc/min cc/min @ 3.0 bar (43.5 psi), iso-octane at 52 C (maker spec)Plug-in

Sensors

Factory sensors by role: part numbers, signal type and fitment years.

SensorOEM part numbersType / signalYears and markets
KnockVolvo 9432570 (Bosch 0 261 231 142; Delphi AS10237)Cross-ref: Delphi AS10237Low confidence13Not yet sourcedVolvo B5254T family (S60/S80/V70 2.5T)Fitment to Focus ST225 / Ford Duratec ST not confirmed by source; Volvo-side listing only

Ignition and triggers

Ignition systemcoil-on-plugResearched, unverified
Valve timingintake VVTResearched, unverified

Tuning notes

Factory load sensing

Wikipedia: B5254T3 uses Bosch ME 9.0 (torque-based) - load sensing not stated.Low214

Factory oxygen sensors

Downstream O2 sensors: yes.Low214

Injector drive

Factory injector impedance: high (saturated). Connector: EV6 / USCAR (inferred from ID USCAR kit listed without adapter).Low46

Driver and calibration

High-impedance injectors run from a saturated driver. Any injector change needs new flow and dead-time data in the calibration. Researched, unverified

Common first upgrades (reported)

Builders most often report upgrading: forged rods and pistons (Fast Car).Low3

Valvetrain, factory engine management and weak points across every generation are on the Ford Duratec guide.

Vehicles with the Duratec ST 2.5T (5-cyl)

Sources

Numbered as cited above. Hover or tap a citation chip to preview it.

15 sources
  1. Factory ratings: Ford Duratec ST/RS 2.5T (Volvo 5-cyl) (E-710) · goauto.com.au · press · retrieved 2026-10-25
  2. Duratec ST ECU (E-816) · en.wikipedia.org · reference · retrieved 2026-10-25
  3. Duratec ST/RS 2.5T (E-1024) · fastcar.co.uk · press · retrieved 2026-10-25
  4. Injector aftermarket fitment (E-1200) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  5. Injector aftermarket fitment (E-1201) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  6. Injector aftermarket fitment (E-1207) · deatschwerks.com · vendor-doc · retrieved 2026-10-25
  7. Injectors / ID1050-XDS fitment (E-1230) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  8. Injectors / ID1300-XDS fitment (E-1231) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  9. Injector Dynamics ID1050-XDS fitment table (E-1260) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  10. Injector Dynamics ID1300/ID1750/ID2600 fitment tables (E-1261) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  11. Injector Dynamics ID1050-XDS fitment table (E-1290) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  12. Injector Dynamics ID1300-XDS fitment table (E-1291) · injectordynamics.com · vendor-doc · retrieved 2026-10-25
  13. Volvo B5254T knock (E-1343) · autoparts-24.com · reference · retrieved 2026-10-25
  14. Factory ratings: volvo-b5234t (E-16240) · en.wikipedia.org · reference · retrieved 2026-11-04
  15. deatschwerks.com product listing · deatschwerks.com · vendor-doc · retrieved 2026-10-25

Evidence ids (E-…) refer to our research register; each records the source, date and confidence.

Not yet indexed: fewer than 3 sensors.